Johnson Controls 128409 TE-68NT-1N00S "1K Nickel Sen

WMR/CLR TEMP SEN 1K NI WL

The Johnson Controls TE-68NT-1N00S 1K nickel sen is a temperature sensor for use with the Johnson Controls 128409 1K nickel water loop.

WMRDC TEMP SENSOR, 1 K INCH NPT, CIRCULAR (1.73-20.6 MM)(1/2-3/8)MALE, RT ANGLE; TEMPERATURE RANGE:-40 TO 105F; MATERIAL:SILICON SEALED BODY, AMB SEALED TERMINAL, 304 STAINLESS STEEL CLAMP AND FLOAT

The TE-68 NT-1N00S is an adjustable temperature controller for three wire, ungrounded WMR, WRT, and CLR applications. This model is supplied with contactor, thermal overload protector, built-in constant current reverse polarity protection circuit for the heater coil, and built-in manual reset overload protection. The output voltage of the controller is 0-32 volt DC.

The Controls 128409 TE-68NT-1N00S "1K Nickel Sensor" Temperature Transmitter is a single loop transmitter that provides accurate temperature measurement for up to 10kW of heating loads. This device has an accuracy of ±0.5 degrees Celsius over the range of 0 to +50 °C (32 to 122 °F) and is intended for use with strip or plate fin heaters.

The TE Connectivity (TE) TempSen allows the user to quickly and easily monitor or set a desired temperature. Force-fitting is not required, as the probe is housed within the hermetically sealed casing. The 4-20 mA monitoring signal and relay on/off output on this probe simplify the automation wiring and reduce installation time and cost.

The TE68NT-1N00S "1-K Nickel Sensor" NTC Thermostat with 10K thermistor and 24 VAC thermistor, is a user-adjustable, non-programmable and non-maintaining type, normally closed bi-metal design.

The TE-68NT-1NI thermistor is intended for use in water/waste water applications within enclosed fluid paths. This product has low resistance and complies to controls NABEAB standards.

Whether you're installing a new system or upgrading an old one, use this temperature sensor to avoid damage and optimize system performance. This Johnson Controls temperature sensor is compatible with the following: Whirlpool, General Electric, Bosch and Rheem residential and commercial water heaters, and all White-Rodgers Multi-Stage Heat Pump Systems; some trademarked names are listed for reference use only.

A nickel sensing thermistor designed for use in a variety of temperature measuring, control and protection applications including refrigeration, HVACR and industrial process control.

The TE Series temperature transmitters with miniature ceramic sensors offer high accuracy and fast response to temperature changes. The temperature sensor is located at the end of a shaft, which makes it easy to calibrate and service. An electronic switching output with smooth current proportional to the temperature difference between the sensing junction and ambient.

Dual element corrosion resistant Nickel "M" Thermometer with a 1/4" immersion probe. Temperature indication on a 0 to 250 C face scale. 0 to 350 C C face scale. 100-240 VAC, 47-63 Hz, 12 VA.

A single pole "on-off" controller for exhaust fans; wire leads with screws; 24 volt DC; 1.18 amp maximum current draw; NEMA 4/4X enclosure rated for use in hazardous (Class I, II, III, and IV) locations.