Honeywell 6289 , Inc. Pneumatic Thermostat Direct.Acting, 2 Pipes, 60F to 90F

PNEUMATIC T-STAT FOR TWO-PIPE SYSTEMS DA SINGLE TE

The Honeywell 6289 Series T-Stat is a direct acting pneumatic thermostat for two-pipe systems, single terminal. It has a 0-100% of FS or zero (0) to 40V DC control signal and is ideally used with electronically commutated motors such as blowers. It features an aluminum body, NEMA 1 enclosure and low-reliability bleed followed by MOCA/WOT/WOB +ALARM indicate.

This Honeywell direct-acting pneumatic thermostat is designed for use on two-pipe systems. It provides 2-stage heating and cooling control with a 13 to 30 volt AC transformer. The unit features a locking wire terminal block identification system and a wafer-style sensor.

Honeywell 6289-2000, 6289-2002. The Honeywell 6289 is Energy Star rated and perfect for your home comfort needs. This pneumatic thermostat is designed for use in up to two-pipe heating or cooling systems and features a direct acting thermopile.

The Honeywell 6289P is a pneumatic thermostat that controls the heat going to your tank and to your home. It uses air pressure as its power source. This thermostat is designed to be used with two-pipe systems only and must have at least one draft inducer for installation. The 6289P is protected by a 5 year limited warranty for residential use. Remember when picking a manual thermostat, you should check that it meets current codes in your area, and because local codes can vary, only a licensed HVAC contractor can advise you on what code applies in your area.

Honeywell's 6289 Thermostat offers multi-stage Operation with fully modulating gas valve for 2 OR 3 Stage operation, which gives the control of your boiler/burner a more accurate level of control. A two stage thermostat has up and down positions where this Honeywell Pneumatic two stage t-stat can maintain low temperatures of around 55 degrees on it's lowest setting. This two stage t-stat was designed to work best in a medium sized heating system where a two zone system is available and it is not a setback type of thermostat.

Honeywell's two-pipe, direct-acting, low voltage, pneumatic thermostat has been designed for heating and cooling systems. The 6289 thermostat is a self-contained unit consisting of a case, plain rotary switch with pointer and bushings, float operated temperature control and a printed coil in the base plate.

This Honeywell 6289 thermostat is designed for direct-acting, pneumatic gas valve systems with 2 pipes. It features a fully compensating temperature controller and steel bracket for mounting.