Johnson Controls 40677 2"npt 3way Mixing Valve 46.2cv With 3-6psi Exposed

2"npt 3way Mixing Valve 46.2cv With 3-6psi Exposed

The Johnson Controls 40677 2"npt 3way Mixing Valve 46.2cv With 3-6psi Exposed is a replacement part designed to fit a specific air-handling system. When the temperature is turned down, the vents will be closed so no hot air escapes. If the room needs cooling, the vents will open and cool air will go into the room; if it needs heating, the vents will close and warm air will go into the room. This whole process happens as you adjust the temperature of your thermostat setting.

The Acu-Rite 40677 2"npt 3way Mixing Valve 46.2cv with 3-6psi exposed contact welded inlet provides custom configurations for commercial or industrial HVAC applications. The Mixing Valve combines suction and pressure capabilities allowing you to mix hot/cold water, heating/cooling water, or steam when needed. The mixing valve is designed to control water temperatures when mixing for specific applications.

Johnson Controls Part Number 40677 2"NPT 3-Way Mixing Valve 46.2Cv With 3-6psi Exposed"

This item is a Johnson Controls 40677 2"npt 3way Mixing Valve w/ 3-6psi Exposed. It is used and appears to be in good condition.

"Johnson Controls 46.2cv 2in. H x 2in. NPT Mixing Valve is a fully assembled two-position, three-way, pilot operated valve designed to mix clean and circulate clean process fluids. This pilot operated mixing valve has a red handle hex bushing, a 3/4" male inlet, a 1/2" male outlet, and uses quarter-turn operation."

This Johnson Controls 46.2Cv valve comes with 1/4" & 3/8" male brass fitting. The valve is 3 way valves, normally closed, normally open and combined. It has a max working pressure of 6 psi. It has 1 waterway. 3 way mixing mixing valves are used in domestic hot or cold water systems to mix hot and cold water together at required temperature for bathing etc. We would recommend the valve to be installed by a qualified installer due to the technical nature of this type of product. It should be fitted in accordance with any current plumbing or gas regulations. The T&D Arm

The Johnson Controls 2" NPT Three Way Mixing Valve is used to mix hot water with cold water to produce a pre-set temperature on the mixing valve.The mixing valve is used in residential applications to meet specific temperature requirements for various types of domestic uses. The Johnson Controls 2" NPT Three Way Mixing Valve is suitable for installation indoors in heated areas, with temperatures ranging between 32 and 104 degrees F (0 to 40 degrees C), with maximum operating pressures between 25 and 230 PSI (1.7 and 16 bar).

Exposed 3-way mixing valve which allows users to set a constant pressure at the mixing valve, as well as a user selected pressure from 0-6 psi. The Johnson Controls EXP2GV82GV2-3 24 VAC control box has been designed with an adjustable control that provides a range from 3-6 psi, as well as a manual control that allows for up to 6 different pressure settings.

The Johnson Controls 40677 mixing valve is designed to provide direct/indirect control for steam applications. The valve's balanced trim weights ensure positive flow direction, even when the energy source changes pressure. It also delivers accurate flow control at low pressure to prevent slug flow. This Johnson Controls mixing valve provides positive IDC control, eliminating the need for IDC relief valves; it minimizes offset balance requirements, reduces installation time and valve piping, while reducing risk of premature leakage.

This compact mixing valve is designed specifically for non-commercial use. The Johnson Controls Series 46 valve combines the features of the Series 36 and Series 38 valves into one unit which can be used on hot or chilled water applications. Designed for smaller systems it offers the smallest footprint on the market.

Specifications