Waekon Industries WAE76564 COP Interceptor, Coil-on-Plug Ignition Tester (WAE-76564)

Waekon Industries WAE76564

The Waekon Industries WAE76564 COP Interceptor, Coil-on-Plug Ignition Tester comes with a full warranty. With the ability to connect to any 12 volt power supply, this specalized ignition control module tester is designed for use on more than just OE equipment.

The COP IGNITION TESTER allows techs and mechanics to test if the ignition coil primary circuit is set at the proper timing range for today's fuel. The Waekon Industries WAE76564 COP IGNITION TESTER is designed to perform a "hard-start" test of the ignition system by momentarily shorting the COP coil primary to ground.

The WAE76564 COP allows you to quickly and easily test 12-, 16-, and 20-volt systems using a standard OBD II connector. The COP is Plug and Play with most OBD II compliant vehicles, and is available in both connector adapters and instruction manuals to provide you with the flexibility to use the module in ISO, SAE, or custom harness connectors.

While the COP ignition tester WAE76564 is a low-cost alternative to an expensive tool, it can be used for all testing procedures in manufacture, research and development. COP ignition testers are available with one coil (WAE75640) or two coils switchable (WAE76564).

This device can be used on both COP and non-COP style distributors.  This device will aid the technician in troubleshooting a no start condition with ignition timing as the possible cause. Most trouble codes P0300-P0306 will require an additional diagnostic tool such as a scan tool or code reader. This device is instrumental in the verification of the correct firing order of the spark plugs to ensure proper detection and plug burn during starting. The tester steps through each cylinder and will indicate if the spark is present by lighting a LED or sounding an audible click. If the LED does not light for a cylinder,

Name the car, truck or motorcycle you want to work on and we will give you the right tools to do it.

The COP ignition tester is a multi-circuit with a range of 0-70 mV, which makes it ideal for the ignition circuit measurement. This COP Ignition tester has a large, easy to read LCD display with multiple test settings and communication ports.