York 025-36448-000 Digital Input Multiplexor

Digital Input Multiplexor

See the Light! Digital Input Multiplexor can turn on up to 64 lights from a single location. DIM is a versatile control solution for Dimmers, Leading/Lagging, Time Delays or other types of load controllers that do not have direct addressability. The DIM2DIM matrix does not require power supply options and uses minimal amounts of wiring.

The Digital Input Multiplexor is an expansion module designed for use on the YQM-8200 series system.

This Digital Input Multiplexor is a usefull device that allows any of the inputs from any one, two, or all three of the building's main fire alarm control panels to be fed to any one, two, or all three of the building's sounders, or voices in an automatic voice notification system.

The new 025-36448-000 Digital Input Multiplexor provides seven relay functions for five digital inputs and two relay outputs. It accommodates five buttons, four rotary dials, or eight toggle switches. An 8 mA output can drive up to a 10 A relay, making this device ideal for many applications including: heater and cooler controls, vacuum controls and pump controls.

The YORK 025-36448-000 Digital Input Multiplexor is a 2-input multiplexer that can be used for both switch and sensor applications. With the built-in RS232 port, this sensor multiplexor is easy to configure and control, and works with your existing controller if utilized for switch detection.

The YORK® Digital Input Multiplexor is designed to meet the needs of your non-complex HVAC system. The Intelligence Controller module provides advanced metering functionality to all three inputs, including operating modes of pulse output, time delay output, or frequency control output. Each input has two digitally programmable settings, for on demand cutoff, time delay relay shutdown, and frequency control. With setup accomplished on the front panel keypad, setup is fast and easy.

The YB2 is a Digital Input Multiplexor (DI-MUX) designed to allow users an easy way to control and monitor 4 wire grounded electrical systems. The YB2 will monitor the state of one or two inputs, and will select and indicate the state of any of its four outputs based on those inputs.

The York Electronic Digital Input Multiplexor 025-36448-000 provides selectable, isolated voltage power on one side of the unit and low voltage alarm/control on the other side. There are 32 isolated voltage outputs, each individually programmable to either an alarm or short circuit shutdown function. An internal relay for each of the 32 digital outputs may be set up for normally open, normally closed or changeover operation.

The Digital Multiplexer/Encoder converts analog and digital inputs to a single, standardized RS-232 serial data link at speeds up to 115.2 kbps. The input circuits require only one analog input source and one logic input source. Combining these two inputs expands the multiplexor's number of digital inputs to eight, an ideal configuration for two four-wire smoke detectors

Designed for use in conjunction with a Universal Multiplexed Output Digital Output System (UMODOS), the PTC CMI-1267 receives and relays six 3–Wire addresses to UMODOS to allow operator battery efficiency monitoring equipment to be installed in any combination at remote sites.

In today's business world, information is more important than ever. Digital Information needs to be transmitted from one point to another as quickly as possible. Only a digital multiplexing system can handle the digital information requirements for your business or organization. The Y-CABLE™ 8W3 is a highly reliable, highly secure digital multiplexing system that integrates over twelve different interfaces into a single cable. This cable is designed for use with off-the-shelf multi-interface data acquisition devices through the non-intrusive 4 wire serial multi-link interface (SMLI™). The SMLI™ protocol

Mix and match components for your job, change your mind at any time, or add new components when they become available. The HMIs are modular, programmable in C, and include an integrated development environment (IDE) with 100% ANSI C source code, debugging software, and online help.