York S1-024-24111-000 24V DPST Relay 24V DPST Relay

24V DPST Relay

This 24V DPST Relay is designed for use in an electrical control system. The relay has a normally closed state, being activated by change in the applied signal to its operating coil contacts. It works with 24V power.

This 24V DPST relay is housed in a plastic case and features three poles and four throws. It can be used to control remotely

The York S1-024-24111-000 24V DPST Relay is a heavy duty electrical switch used in industrial automation and control applications. This relay is mainly used in 24VDC system to transfer power for controlling on & off operations.

The YORK 24V 1A DPST relay is designed for critical power switch applications requiring positive switching. It has a DC coil voltage of 24VDC and relay contacts rated 3A at 125VAC. It also contains two auxiliary switch contacts. The 24V 1A DPST relay has an operating current of 1A and a resetting current of 24mA.

The 24VDC adjustable amplitude, square wave output relay offers superior contact ratings and up to 1Amp of load current. The square wave output provides reliable ON/OFF operation while the adjustable amplitude mode has three selectable output levels. This square wave sensor type SPDT relay is designed to provide fail-safe switching in DC circuits that require accurate amplitude or pulse width. Output voltage can be up to peaks of 240VAC (RMS). Select output voltages are available for desired requirements.

This 24 V relay is designed to work with all motorized devices. It provides 12 Amp Relay contacts when in Automated mode, or 24 Watt Contact when in the alarm state. If alarm conditions are satisfied, the contact will close 24V DC. Configuration can be changed using wiring instructions in this document.

The EEI-075 series multi-pole single throw (SPST) or double pole single throw (DPST) contact relays are designed for use in automatic control circuits requiring non-latching SPST or DPST switching. The EEI-075 series are normally open type relays with the common terminal connected to the normally closed terminal through a DPST latching coil or an SPDT latching coil. When the coil is not energized, the contacts are open.