RHEEM 232285 Water Heater High Limit Kit - Auto Reset

Kit - High Limit Auto Reset

Auto Reset High Limit Kit

Our Auto Reset High Limit Kit is designed to fit select Rheem water heaters and will automatically shut off the power when the temperature of the water reaches 195°F before it can boil. This high limit kit will protect your house from potentially catastrophic damage caused by scalding hot water.

Think of our patented Auto Reset High Limit kit as an added safety measure for your Rheem water heater. If the pilot light goes out, the springs inside the manifold will push up a pin to keep it lit, instead of going through the process of lighting the pilot light all over again.

RHEEM high limit auto reset water heater repair kit with "E" ring, upper washer, lower washer, gasket seal, stainless steel bolt with lock washer and nut, plus an instruction sheet.

RHEEM AUTO RESET High Limit Kit for RHEEM and RUUD water heaters is designed to provide critical safety protection. The patented, complex electronic internal design helps prevent excessive natural gas pressure surges that could damage your heater, its piping, or other home components. This high limit kit also incorporates a new self-diagnostic monitoring feature that requires no input from the installer and automatically informs the installer if there is an improper connection or defective component. The resettable electric high limit safety shutoff switch opens the gas valve when it senses an excessively high inlet gas temperature to protect the heater and home from potentially

This Rheem water heater high limit kit will protect the tank and its surroundings from scalding water. It is built with an auto reset which gives you peace of mind about your water.

The new Rheem 232285 high limit kit has been designed to help protect the most important part of your water heater--the gas control valve. This will help decrease any chance of a dangerous heater malfunction or a leak smoldering undetected in your home. The high limit also functions as an auto-reset, so if the flame is out for any reason, it will automatically relight itself when conditions are safe