Baldwin 0380102 0380 102 SURFACE BOLT 8

0380 102 SURFACE BOLT 8

The Baldwin 0380102 0380 102 SURFACE BOLT 8 is constructed of a high carbon steel and designed to self-drive into wood for lag bolts.

This 8-1/2-inch diameter Surface Bolt is used to create lightweight, floating surfaces with large areas of direct-to-wall contact. It is a fast and efficient way to mount systems to wall studs without the need for a plate or sleeve.

This item is 4 in. x 2 1/4 in. x 1/2 in. long to fit on any door surface and will fit all Baldwin Surface Bolts (sold separately) and some competitors' bolts up to 14 mm head diameter. LIMITED LIFETIME WARRANTY

Our Surface Bolts have a unique design preventing marring of trim and/or surface on which they are mounted. They have a low profile head that can be used as a shelf-support bolt when using the long thread version. Self-drilling, self-tapping screws make it easy to mount these bolts without drilling pilot holes. Silver finish.

There is always the right piece of hardware for the job. Baldwin Surface bolts are ideal for use in pre-drilled holes that need extra strength. They have a wide countersunk head to spread the applied load over a large area and they are set with a roll pin to retain them in place.

This item is designed to be mounted through your surface. Our surface bolts are specifically designed for installing into concrete or other surfaces that will be used during the mounting of the cleats.

Cabinet bolts without threads for flush or surface mounting.