3 1/4" FLAME SENSOR 30" LEAD
It is also used to start or shut off a gas valve when the pilot is on
The ROBERTSHAW 10-760 is a 3 1/4 inch flame sensor with a 30 inch lead
This flame sensor can be used for both gas and oil burners
The pilot will remain ON for approximately 30 seconds after the last time the flame sensor is activated by an open flame, this allows you to re-light your pilot after it has been extinguished by the flame sensor
The Robertshaw 10-760 Flame Sensor provides a quick and easy way to protect against fire hazards in liquid propane or natural gas fired appliances
This flame sensor is compatible with 100% Natural Gas or Propane
The flame sensor has a built-in heat sensor that reacts instantly to the presence of pilot light and the resulting reflected radiation which changes the resistance of a sensing element
The wafer-type flame sensor is designed specifically for natural gas, liquefied petroleum and propane applications
It fits all gas logs, Vented Fireplaces and for use with gas or wood burning fireplaces
This remote flame sensor fits models: A-36, AVS-36, FV36, G36 and GV36
The sensor has a multi-voltage power supply
They are suitable for use in gas burners, gas appliances and furnaces that produce either visible flames or infrared radiation
The ROBERTSHAW 10-760 is a flame sensor designed to automatically shut off the pilot when activated
For complete safety protection, install one flame sensor per heat source or appliance in which a fire could occur
SPECIFICATIONS:
It is shipped with 50' of cable, an adjustable, locking bracket and mounting screws
The RLR Series Flame Sensors are designed for use in fire alarm systems to monitor the presence of a flame
The ROBERTSHAW 10-760 remote flame sensor is an accessory to the ROBERTSHAW 10-750 Remote Pilot
The pilot remains OFF until the flame sensor senses an open flame and then closes
ROBERTSHAW 10-760 10-760 REMOTE FLAME SENSOR REMOTE FLAME SENSOR
A photoelectric cell converts this change in resistance into a proportional electrical signal, which is then transmitted through lead wires to your gas control panel
The 10-760 is a flexible cable flame sensor measuring 3 1/4" with a 30" lead
A remote flame sensor will trip when exposed to heat from a flame, such as a pilot light on a water heater
The flame sensor is required for proper operation of the pilot and must be installed in an area where it will detect a fire and respond within its operating parameters
This flame sensor can be used to convert an appliance from manual to automatic operation
It comes with the mounting hardware
The Robertshaw 10-760 remote flame sensor is designed to sense a pilot flame and control the gas valve to the appliance