HEIL QUAKER / ICP 1172550 1172550 CONTROL FURNACE 1-STG

CONTROL FURNACE 1-STG

The ICP Heil Quaker Control Furnace 1-Stg with 1172550 Model # is a Commercial Grade, one stage electric limit control furnace designed to help ensure optimal comfort for your home or business. The Heil Quaker Control Furnace, with model number 1172550, offers many features that can be customized to meet your heating needs. This unit automatically regulates the temperature in your home while helping you to save money.

The Heil ICP furnace is a high efficiency, low temperature, modulating gas furnace. The control furnace-1 stg with external burners and industry exclusive variable power flame technology. This unit controls up to 117 000 Btu/h (120 MBH) at maximum power. This furnace features a standard 4? vent stack for a rooftop installation and has the ability to run with 115 volts AC or 208 / 230 volts AC at 50/60 Hz.

The ICP Control Furnace 1 Stage by Heil is a high capacity furnace with an aluminum chamber and brazed copper tube coil. This top-of-the-line residential gas furnace is designed for the comfort demands of modern living, while saving you up to 30 percent on your heating expenses. Manufactured to meet demanding quality standards, this furnace utilizes SmartBurner technology to make it energy efficient. The standard ECM motor is certified for up to 2 million hours of operation. The combination electric heat strip and air filter keep the blower protected from outside elements and enable it a continuous 24-hour run time without

The ICP 1172550 control furnace is a single stage thermostat with a 1/8 in. NPT gas connection and 240 VAC power input.

This ICP 1172550 1172550 Heil Quaker Control Furnace is designed for a/c split systems having a single stage blower motor and a modulating gas valve to provide reheat, when ordered. Available for 115 V or 230 V input voltage. A two-speed motor allows the furnace to operate at full load when furnace airflow, heating and cooling demands are low (typically during nighttime hours), and then switch to a lower speed when heating and cooling demands are higher.

The system control module is an electrical part that uses frequency modulation to communicate with the blower motor and other internal components of a furnace. It can be installed in any position, but it must be installed horizontally, with the display towards the front of the furnace. This ICP 1172550 Heil control furnace is easy to install as it is compatible with most Bryant and Payne 38M series furnaces.

The Quaker/ICP has the following features: 115/230 Volt - 60HZ, Exhast Fan Energy Saver Start Technology, Programmable Fan Delay Auto Changeover, Keypad Digital Display for set up and diagnostics, EstiMate IV Utility software, all that is required to get the furnace / air conditioner running is a Bryant-approved thermostat.