REZNOR 197032 197032 PRESSURE SWITCH UDAP,S PRESSURE SWITCH UDAP,S

"HiAltitude#Switch .45""wcPink"

HiAltitude#Switch .45""wcPink"

HiAltitude#Switch .45""wcPink

A pressure switch for a high altitude balloon. It was manufactured by REZNOR in 1970, and is stamped UDAP,S. The connector is for a 4-inch rubber hose. The glass enclosure inside the plastic case is broken-off. It is marked "HiAltitude#Switch .45"wcPink"

Electrical-Pressure Switch; ""HiAltitude#Switch .45""wc, Pink; Prevents water hammer caused by pressure surge from water heater or pump; Quick &easy to install; 100 PSI Rated

HiAltitude#Pressure Switch .45""wcPink"

This Pressure Switch will activate your regulator based on the pressure inside your tank. If you are using a primary and backup regulator, it is recommended that you do not mix HiAltitude or any other manufacturers product with various switch needs. This will allow you to purchase only 1 type of swit

The UDAP Hi-Altitude pressure switch is designed for use in aircraft, accessory power units and ground power units with high altitude requirements.