AMANA 162977 -Amana 20044403 DraftInducedBlowerAssembly

DraftInducedBlowerAssembly

The DraftInducedBlowerAssembly is designed to fit the Amana manufactured housing models of 5TKX18-M, 5TKX20-M, and 5TKX21-M, and will also fit several other housing models that are currently being manufactured. This replacement part includes a blower wheel, an upper outlet draft diverter assembly, a lower inlet draft diverter assembly, and a poly carbonate flexi-tube. The fan motor is designed to draw

The DraftInduced Blower Assembly - 990E Series is designed as a replacement for the blower assembly on certain (AMANA) window air conditioners. It is compatible with windows that meet these properties: Bedrooms or Living Rooms: 8ft to 18ft How to select The DraftInduced Blower Assembly - 990E Series fits between the front and rear panels of your window air conditioner, typically on the left side. To decide if this is the correct part for your air

The Draft Induced Blower Assembly is used for forced air from ducted vents from RAC systems equipped with a blower.

When you are purchasing a new item, you should make sure that it complies with the latest energy-efficiency standards. Doing so ensures that you'll enjoy lower rates over time while also helping to protect the environment. The Amana 20044403 Draft Induced Blower Assembly has been tagged with the Energy Star label to indicate that it meets or exceeds the Air Conditioning and Refrigeration Institute's energy-efficiency requirements. There are a number of guidelines that products must meet to guarantee they can earn

The draft induced blower assembly is an optional, post-manufacture field retrofit item. This assembly will convert your furnace from a downdraft venting system to a draft induced venting system. To order this high efficiency blower assembly, contact our part department at 1-800-526-8326.

The draft induced blower assembly is located on the bottom of the fresh air grille. Its job is to pull air from outside into the system and to distribute it through the duct system. This assembly consists of a draft inducer motor, a mounting collar with gasket, mounting yoke, wiring harness with connector (4 wire connector), brake pad and holder, and a plastic casing. The design problems with this assembly are random intermittent noise, smoke emissions(lots of smoke), and motor over

The draft induced blower assembly, also called a downdraft booster fan, is a vent system component used on a gas range or oven. It is responsible for moving cold air to the burners of the range. This part can be damaged if the range isn't installed properly or if it's moved excessively. Damaged parts should be replaced immediately to prevent damage to the range and other components.