My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New Account
Free Shipping
In stock
1 days
3-WIRE IGNITER/FLAME SENSOR & GASKE
Designed for use on propane gas with natural gas available as an option. The 3-wire system features a flame sensor and gaske that act as a switch to shut off the gas supply if the flame is extinguished and turns the gas supply back on when the flame is re-ignited.
The 3-Wire Igniter/Flame Sensor is designed to provide output power that will ignite Goodman units and similar equipment with a high sensitivity flame sensor. They are designed for use with natural gas only and can be used for air-cooled heating coils. The Igniter series of gas controls are designed to operate low voltage, 24 VDC motors, such as direct fired motors and fan coils; low voltage water heaters; oil burners; and furnaces with emergency heat.
The TELEDYNE LAARS 2400-526 3-wire igniter/flame sensor is designed for use with fuel fired hot water heating systems. It senses actual flame and aids in fluegas management by forcing all of the current generated to go directly to the burner.
Designed expressly to be fired through insulation or brick, this gas igniter/flame sensor has a gas adaption kit for use with natural, butane, propane, and mapp gas.
FEATURES: Three (3) wire flame sensor and gas piping transceiver assembly Accepts all three (3) voltage outputs from the ignition or flame module of Teledyne LFS Series Antennas with 3 wires. Flame sensor measures flame activity on natural gas, propane, or dual fuel fixtures Sensors are designed to fit 1/2 inch NPT pipe for easy installation
The Laars Sensors and Flame Sensors are designed to determine when a gas pilot or open flame is present. These are very handy when used with our Solid State Igniter/Flame Sensors.
The LAARS® Flame Sensor and Gas Key Assembly, Model 2400-526, is designed to detect flames in gas-fired ovens. The flame sensor and gas key assembly allow for quick and easy installation of the LAARS® Natural Gas Oven Flame Detection System in ovens using mechanical or electronic ignition systems.
1 days
Laars Heating Systems
The Laars Heating Systems 2400-526 Ignitor/Flame Sensor & Gasket is a replacement part for the Laars Heating Systems 2400-526 furnace. This part is used to detect the presence of a flame and...
Laars Heating Systems
This Laars Heating Systems 2400-552 TELEDYNE BOILER CONTROL SENSOR is a replacement part for your boiler. This sensor monitors the boiler temperature and sends an alert if it falls below a certain...
Laars Heating Systems
This Laars Heating Systems 2400-138 Ignitor/Flame Sensor Assembly is a replacement part for your furnace. The ignitor/flame sensor assembly detects the presence of a flame and activates the furnace.
1/2 HORIZONTAL VALVE BODYHoneywell 1/2 HORIZONTAL VALVE BODY is a horizontal valve body compatible with 11-Series valves. Individuals can get it from us at reasonable prices in terms of the high...