BECKETT 807 Igniter 3666 NUT 3/8 SPLINED

BULKHEAD FITTING LOCKNUT

A bulkhead fitting for a 3/8 in. (10 mm) gas hose. It has a nut which acts as an integral locking collar and is secured by an SPLINED BULKHEAD FITTING LOCKNUT on the male threaded end. Push-in fitting for plastic pipe and DIETZGEN Igniter 3666 burner tube nuts.

The Beckett 807 Igniter 3666 Nut 3/8-spilled Bulkhead Fitting Locknut is suited for applications where the pump output must be rerouted 90 degrees from the engine-mounted fuel rail. This allows installation of a larger fuel tank without the need to run additional plumbing and hoses to the engine compartment.

Becket's 807 Igniter Bulkhead Fitting Locknuts are designed for use with a disposable bottle of igniter fluid. They use a 3/8 x 16 threads per inch. They have a hex head that has a flange and three socket drive holes. These nuts are easy to take apart and allow you you to leave the bottles on your pipe where it exits the boat. These fittings are meant to be purchased in bulk and used over and over with the appropriate type of fluid.

The 807 is a 3/8 inch spigot locknut with an Igniter 3666 nut is used for joining two or more lengths of threaded pipe systems.  The nut prevents looseness when the soft copper tube is not secured by threading the tube into the hardened fitting.

A nut for attaching a fitting to the end of a bulk head where threads do not already exist. Beckett's patented roll pin hole design prevents skipping and increases the torque strength of the nut by almost 70%.

Just tap your Beckett® locknut wrench on a load nut of a 3/8 network fitting or T-fitting and it will spark to get your line up and going.

The BECKETT 807 is a nut designed for use with the Hose End Assembly. The nut is made of steel and is designed to hold the Hose End Assembly on the tank.