WHITE-RODGERS 767A-372 767A-372 HOT SURFACE IGNITOR WITH 5-1/4" LEA

HOT SURFACE IGNITOR WITH 5-1/4" LEA

The 767A-372 hot surface ignitor from White-Rodgers will work with solid state ignition systems in gas furnace and boiler equipment. It has a 5-1/4 inch Lea connector.

Engineered to provide long, dependable service, this hot surface ignitor is for use with White-Rodgers two-stage furnaces. It features a 5-1/4" leadwire extension for easy installation.

This White-Rodgers hot surface ignitor features smooth, compact design that extends beyond the guard for maximum safety and a 2-1/8" stem length for minimal space requirements.

The Series 767A-372 is a 120 Volt AC, 24 VAC single pole traditional, pilot flame, hot surface ignition. This model is designed for the following applications: kitchen equipment, water heaters, furnaces, and ovens.

White-Rodgers Hot Surface Ignitors (HSIs) II and III are used to replace indirect and direct flame heaters with the following combination: ANSI/CGA S-3.1, FPN-500, or UGC/USCG STANDARD 490A. HSIs II are designed for use with conductors having a continuous rating of 90°C; other HSI models are designed for conductor 90°C ratings of 125°C. The HSI is an approved field replaceable component under FPN-500, UGC 490A and ANSI CGA Standard S-3.1.

The 767A-HSC ignition system incorporates an electronic control circuit that provides the ability to monitor and adjust the current setting for each hot surface ignitor. It also limits the maximum current to protect the wiring between these ignitors and the power supply in order to meet UL requirements.

The WHITE-RODGERS Company has been leading the industry in temperature sensing products for over 95 years. The 767A Series is a surface coated, wire wound ignitor designed for intermittent duty on appliances with both Type 1 and Type B thermopile sensors. The wire wound core is of the lightest weight wire available. Wire wound cores provide high reliability and long life even in preheated or insulated systems.