OEM REPLACEMENT NITRIDE HOT SURFACE
WHITE-RODGERS 99961 REPLACEMENT NITRIDE HOT SURFACE IGNITOR The 99961 transformer can be used with any 80 volt thermostat. It features a ceramic core and pellet resistor and is suitable for any application requiring a resistance of 3.2 Ohms.
Discontinued by Emerson and no replacement stock available. This unit is a custom made replacement for this style of hot surface ignitor. It has an 80V Silicon Nitride Hot Surface.
Designed to fit old and new systems, the 99961 hot surface ignitor is manufactured with a special silicon nitride insulator that is corrosion and abrasion resistant. 900 Volt
Designed for residential type gas water heaters with a rating at or above 80,000 Btu/hr. and for commercial water heaters requiring an 80 volt ignitor. This hot surface ignitor is designed to be installed in the upper right hand corner of the burner enclosure. This patented technology provides one-step, dual function assembly by utilizing a fuse wire wrapped around the silicon nitride, which creates the hot surface. The fuse wire serves as both an arcing electrode and armature. This
The White-Rodgers 99961 Emerson Hot Surface Ignitor is used to ignite your furnace. The product is an OEM replacement and comes with a 5 year limited warranty.
This HOT surface Ignitor is a replacement for White-Rodgers. It is used in most all components of the white-Rodgers systems that use 80 volt control voltage to operate the system. In most cases it will have three wire leads which should be properly connected to the white-Rodgers controller board or relay board. Within some of these units, they may be used as a direct replacement for other makes of hot surface ignitors that are rated at either 70 or 90 volts. This replaces the
This hot surface ignitor controls the heat, so your stovetop stays safe for you and your family. It's designed specifically for use with White-Rodgers furnace products. The Teflon insulator stays cool to the touch.