ROBERTSHAW 4548 HOT SURFACE IGNITION MODULE HS780-3 HOT SURFACE IGNITION MODULE HS780-3

HOT SURFACE IGNITION MODULE HS780-3

This HOT SURFACE IGNITION MODULE HS780-3 was born to work and built to last. With commercial quality control, the HS780-3 is a powerful addition to any grill or smoker.

The new HEATERMARK® HS780-3 Hot Surface Ignition Module is designed to replace the broken or worn out hot surface ignition module found in older model Roper ProCook RQ™/RQ™, RQ™/RC™, and RQ™/RSC™ griddles. Using the latest technology, this HS780-3 Module has a microprocessor controlled circuit that monitors the hot surface igniter plate temperature and controls the amount of current to the plate. This allows the module to ensure that you always have an operational hot surface igniter system. The HS780-3 also features a

HS 780-3 20 Amp, 240/208 volt, surface mount hot surface ignition module that is designed for use with the following equipment: Pressure Jet CJ760, Tandem pump TPS370, Condensing pump CPS770, Water heater WH780. The HS780-3 creates a hot surface ignition to ignite pilot gas flow in pressure fluids requiring combustion.

The HS780-3 is a low voltage Whole House Module designed for controlling gas appliances. Products compatible with this HS780 Series include:

The HS780-3 is designed for one- or two-pipe systems. The HS780-3 allows a system designer to install a portion of a direct vent gas heating system for radiant floor heating and domestic hot water (DHW). The HS780-3 controls gas flow to the stand-alone appliance by providing precise, programmable, manual control of gas valve operation. The module's integral PID thermostat accurately monitors return gas temperature and automatic operation begins when the temperature reaches set point and continues until it exceeds the…

The HS780 Series Ignition Module is a single-phase primary control device that provides 4 types of control:

The Robertshaw HS780-3 is a heater module designed for use in the FHP-5, FHP-6 and FAHR-1 infrared furnaces. The HS780-3 features a .070" thick stainless steel heat exchanger for added durability.