LENNOX 80C93 80C93 BLOWER-PURGE ASSEMBLY BLOWER-PURGE ASSEMBLY

InducedPurgeBlowerAssembly

The InducedPurgeBlowerAssembly is used for either heating or cooling a home. It can be used in a portable or permanently installed unit. The furnace features a built-in outdoor air sensor that automatically measures the temperature of the air and controls the speed of the blower. The unit supplies air from 0 to 70% relative humidity to maintain desired comfort levels. Availability: On Request

BYPASS PRINCIPLE: THIS PRINCIPLE IS USED TO REDUCE THE EXHAUST AIR COEFFICIENT BY PLACING THE BLOWER AIR THROUGH A PASSENGER CARRIER. The Lennox InducedPurgeBlowerAssembly 80C93 is used with the 65NN80C93 Motor to replace the Lennox Part Number 57D+380.

The Lennox® PMAC-400IF (InducedPurgeBlowerAssembly) is a two-speed air inducer blower designed to purge the indoor air duct system for the leak check test of split type, indirect fired indoor furnaces.

The Lennox 36 and 80 Series Induced Purge Blower Assembly for 2 through 12 ton systems consists of a catalogued blower, Inducer, Swing Check Valve, Drain Valve Body Assembly, #5 Locknut, and a 6 foot Auto Disconnecting Tubing Assembly. The units are used to create a vacuum in the air-conditioning line prior to opening the cooling line service valve on the line side of the system. This is required to remove all refrigerant from the system so

Includes blower+vacuum switch; tube sections; check valves; automatic filter-drier and all necessary hardware for installation. This assembly should be used on Lennox MP12/200 gas/oil burner models as original equipment or replacement part. LennoxMP12/200gas/oilburnermodelsasoriginalequipmentordemorandumofmanufactureprovidesforintegratedcondensingunitwiththefollowingfeatures: TheInducedPurgeBlowerAssemblyisrequiredforuse

A necessity on Lennox commercial furnaces, this induced purge blower assembly relocates the suction opening to the rear of the chamber helping remove combustion products and air pollutants from the heating area. Used in parallel or series with your existing induced-purge blower assembly, this additional blower improves efficiency even more. [1]

This Lennox Induced Purge Blower Assembly keeps the system free of contaminants and guards against water damage to the blower's motor. It can be installed in the outdoor unit as well as in the fan-coil unit. This component includes mounting hardware. 1/8 Air Diffuser for Use with GX Series Roof Top Units and Condensing Units *** This air diffuser is used on a number of Lennox equipment including Lennox gx/gxa series units and condensing units