LINEAR LIMIT FOR VP-2,VP-3,WHK-2,WH
TJERNLUND 950-2064 950-2064 LINEAR LIMIT FOR VP-2,VP-3,WHK-2,WH
The 950-2064 Linear Limit for VP-2, VP-3, WHK-2, and WHK-3 Working Height Control Systems is a linear limit designed to shut down the working height control system if a fall hazard is detected above the boom. It is typically mounted on the pipe of a telescopic boom or on the jib of an articulating boom.
The Linear Limit VP-2,VP-3,WHK-2,WH is used to limit the span (travel) of the finger tip and tip adapter. This linear limit is for the following linear actuators: VP-2, VP-3, WHK-2, WHK
Linear Limit VP-2-0 psig, VP-3-1 psig, WHK 2-6 psig
This device is a safety control for use with the VP-2, VP-3 and WHK-2. It is a stand alone control used to limit the open range of motion when the user applies pressure against the backrest. This product converts an ergonomic pull-back chair into a powered chair.
This linear limit is used in conjunction with 951-8503 or 951-8504 for precise measuring in VP series scales.
The Linear Limit (AGC) is used to describe the speed controller settings for standard linear actuators when working with limited mechanical loads.This accessory increases the signal from the PLC for the output, so that the actuator can move higher and faster.The diameter and length of the actuator do not have any effect on the function of AGC.