ARMSTRONG AIR R40663-002 "IGNITOR/SENSOR "IGNITOR/SENSOR

"IGNITOR/SENSOR

"Ignitor/Sensor Assembly for Armstrong Air Furnaces.

With this Ignitor/Sensor, you can now cook on your Rangetop Vision range with the greatest of ease. This Ignitor/Sensor is designed to provide a safe means of lighting the burners for cooking. This product has a reset switch which will allow customers to replace parts rather than dispose of their entire range.

An ignitor/sensor that is located on the side of the gas pack and has been fabricated by using new technology. This is a part that will ignite the gas once the flame of a barbecue grill lighter has touched the top of the ignitor/sensor.

This Ignitor/Sensor assembly for Armstrong Furnace/Boiler is used to control the ignition of the gas burner. This device has a F-connector to connect it into the gas line and a knob on top to adjust the flame.

The Armstrong Ignitor/Sensor has a small area which is used to light the pilot and inform the thermostat that the pilot is lit. The sensor does this by using a thermocouple to read the pilot flame, when lit, it produces a voltage signal that will light the ignitor's lamp and indicate a flame to the thermostat. Once the pilot has been lit, this ignitor will not allow it to go out. If there is no flame present while this ignitor/sensor is energized for more than 2 minutes, it will send a fault code back to the thermostat.

Airing out the whole house is easy with the Armstrong Air Ignitor/Sensor; a heat-sensing, automatic gas pilot ignition that controls firebox shutoff and pilot operation. It features an adjustable dial for adjusting temperature control and 4 pre-set cycles: low, high, and auto thermostat.

A decorative air element that comes with a matching 1/8" mounting bracket is embedded in a ceramic base. The element glows bright blue when plugged into an electrical outlet and controlled by the included remote control.Lighting is best sited outdoors or protected from moisture. Remote control is equipped with a built-in on / off switch to avoid draining batteries during storage. To preserve product' integrity, do not bend Sensor/ignitor when handling.