Honeywell 2012 AT72D1089 TRNSFMR 120V-24V FOOT MT TRNSFMR 120V-24V FOOT MT

40VA TRANS 120V-24V FOOT MOUNT AT72

Honeywell TRNSFMR 120V-24V FOOT MT Used (AT72D1089). Unit has some scratches from use. All face plate works and control power is present.

Honeywell's AC Transformer- 120 Volt- 24 Volt Foot Mount provides power to the following models: TC11C, TC9090AW, TC9060W. This 120V/24V foot mount transformer is 120 Volts AC only.

The AT72D1089 is a screw terminal foot mount AC power supply with a removable field-attachable plug. It is ideal for applications that require field wiring between the source and load.

The Honeywell AT72 Digital 400 Series Fuse Transformer comes with a 3-foot power cord attached to a plug providing an inlet for the included remote fuse holder assembly. Once installed, the AT72 designed for installation inside electrical cabinets or other enclosures, distributes 120V 24V power to each of two separate 120V/24V devices. The transformer is equipped with terminal blocks allowing you to feed power from three different voice/data circuits.

The new AT72D1089 120V-24V Solid State High Voltage Transformer is designed to work with the Honeywell LS-9007 Series, LS-8009 Series, and LS-8000 Series of Flood Sensors. This transformer will convert 120VAC power to 24VDC and step down 24VDC to 9VDC for use with the listed Honeywell flood sensors. Certain models require the AT72D1078 Transformer; please contact Honeywell for more information.

The AT72 foot-mount transformer replaces the transformer included with your thermostat to allow for hardwiring. It is compatible with a variety of other thermostats in the Attachment Series line of products. The transformer can be mounted on vertical or horizontal 4" rough-in, and it is UL/CUL certified and rated for 120-Volt~, 60-Hz single phase electrical systems.

This transformer is a heavy duty, 120 volt - to- 24 volt dc power Source designed to operate an external NEMA 12 enclosure. It has a maximum output of 40VA. The transformer module also provides output receptacles on the terminal strip for two 120 Volt AC lights or other 12 volt DC loads; both devices are required for the load to be turned on. It uses five 0.250" diameter mounting holes placed 37 1/2" center-to-center and has three #14 - 3/4" mounting studs.