BLOWER MOTOR 115V
Frigidaire UltraFryer Blower Motor 115V
This Blower Motor is engineered to meet or exceed original equipment specifications. For the price and performance, it can't be beat.
This blower motor is used to provide forced air circulation for gas grills. Motor operates at 2.2 amps and 115 Volts to power a 13 inch fan.
This Ultrafryer Blower Motor is a 2.2 Amp, 115 volt blower motor that is 3-1/8" in diameter and 5-3/4" long. This item can be used in the following models: Ultra Fryer, ULTRAFRYER F13143.
The Ultrafryer® F13143 Blower Motor, 115 V 2.2/Amps is used on the Ultrafryer® Heat Pump Air Fryers (models 100300, 100650, 100200 and 100400).
The blower motor is used on various models of appliances and equipment. The blower motor is located inside of the appliance or equipment near the air filters. Two wires will attach to it. A fourth wire may also be attached which runs down to the capacitor. The blower motor may be covered by a metal cage on the inside of the appliance or equipment and have retaining clips holding it in place.
Attach the grid to the tub, and install the blower motor onto the blower assembly. Verify correct phase rotation when attaching the blower motor. Phase rotation should be 180 degrees out of phase with the manifold heater on 4-1/2 and under frame grinders, and 110 degrees out of phase with the manifold heater on 5-1/2 frame grinders. Next, set pulley sprockets so that each is visible through a square opening on opposite sides of the platen as shown in figure 1.