S.U.R. and R Auto Parts

This is a cam pivot pin for the SRRFT610 automatic parts inc. This part is used to keep the cam in place during assembly.

This is a cam knuckle for a SRRFT615 automatic transmission. It is a replacement part for a car that needs to be repaired or replaced.

This is a power shaft for SRRFT625.

This is a 1-pack of SRRFT630 Thrush Washer parts. These were used in a Thrush washer.

This is a die body for the SRRFT645 automatic parts inc. firearm. It is made of steel and is designed to help with accuracy and function of the firearm.

This is a 1-piece plastic carry case for the SRRFT670 FT351 scanner. It is designed to protect the scanner from scratches and damage while in transit.

This is a blank turret for the SRRFT710 Auto Parts Inc. machine.

This is a die for use with a SRRHFT205 automatic parts changer. It is 3/16 inch wide by 4.75 inches long and has a 45 degree angle. It is made of steel and is DIN approved.

This is a 1/4" 45 degree die for use with AUTO PARTS INC SRRHFT210.

This punch is designed to remove rivets and screws in a 3/16" diameter hole. It has a 45 degree angle and a 3/16" diameter hole.

This punch is designed to cut 45 degree angles in sheet metal. It has an automatic feed system that makes it easy to use.

This punch is used to make a hole in a metal sheet. It has a 3/16" diameter and a 4.75mm depth.

This is a punch for 1/4" DIN size. It has a serrated edge for precision.

This is a punch for a SRRHFT325 auto parts. It is a 3/16 inch and a 1/4 inch size. It is for a 45 degree angle.

This is a SRRLHD7 7mm flexible driver tool. It is designed to help remove and replace 7mm drive belts.