T&S Brass BOCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP CRAFT MFG. COMPANY 975323

OCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP

Our OCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP CRAFT MFG. COMPANY 975323 [add to cart] is made of solid brass and comes in a chrome finish. It is designed for use with 1/2 inch water-supply lines and has a pipe thread connection of 3/8 inch. This special stop prevents the tubing from pulling out unexpectedly.

The BOCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP CRAFT MFG. COMPANY 975323 is a part of the T&S Brass Outlet Xtra line of products.

Our BOCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP CRAFT MFG. COMPANY 975323 is a 1/2x3/8 Compression Xod Stop manufactured from high quality brass. This Stop is used to limit the water flow through lead free residential valves.

The BOCR19XC 1/2X3/8 COMPRXOD CP ANGLE LEAD FREE STOP CRAFT MFG. COMPANY 975323 from T&S Brass builds a bridge across your copper pot or tubing for solder to flow freely and create a secure grip. This stop comes in a gold finish and fits standard 1mm to 3mm copper tubing. It is typically used in sausage kettles and refrigeration.

The CP angle stop is used as a piping stop for change of direction in straight runs, and to prevent rotation of piping running at an angle. It provides support for tubing or hose at any angle coming off a control valve, and may be used as a branch connection to PVC piping. The stop contains an internal sleeve that springs up and down to give support to the tubing or hose. The external sleeve is threaded to accept screw type fittings, or it may be trimmed off if not required. Specifications: Thread Size - 3/8" ID - 1/2" x 3/8" OD Lead Free Compliant

This lead-free brass compression stop is manufactured by T&S Brass as part of their line of specialty products. Visit our site for information on other T&S Brass products.

Compression stops are used to limit the travel of the valve stem in a compression, or lead-free ball drain. The PVC spud is inserted into a Compression fit stop, and then coupled to the valve body. The rigid plastic faces will contact flush when the fitting is fully tightened. The stop can then be cut at the desired length using a hacksaw, or seamed shut for permanent installations. Homogenous plastic construction ensures that each stop has accurate dimensions and meets NACM standards.