"Pillow Block
While the design of Browning and Century VPS bearings, seals and locking mechanisms are very different, they can be organized into two basic categories – one featuring rubber seals and a thrust washer for support, plus a flap-covered lock, and the other with a snap-on spacer. I did not apply that distinction here because Browning bearings are interesting because they employ both systems – the rubber seal in the pillow block part and the flap-covered lock in the bearing housing."
Browning Commercial VPS Series are one of the most common style of air handling duty components. This Allen-Bradley style ball bearing is designed for use on equipment subject to dirt, dust, oil, and grease. Pillow Block bearings are in-line mounted components with a bore which accepts a shaft or housing. The base is undercut allowing the bearing housing to sit lower than the mounting surface for easy servicing of enclosed components.
Browning VPS-219 AH Pillow Block Ball Bearing, 2 Bolt, Air Handling Duty, Setscrew Lock, Contact and Flinger Seal, Cast Iron, Inch, 1-3/16" Bore, 1-11/16" Base To Center Height carries a lot of interesting factors. If you wish to know further in this location finding instruments, just read the main features underneath.
This block features 2"(51mm) OD flange and 1-3/16"(29mm) ID bore. Base to center height is 1-11/16"(42mm). Control configuration is illustrated in the accompanying figure.
engineered for transmitting power at low speeds and for operating under severe operating conditions…
The Browning VPS-1909 is a 1-3/16 inch diameter ball bearing with two bolt pattern with air handling duty, contact and flinger seal, threaded rod lock nut, cast iron base. The height is 1-11/16 inch.
Air Handling Duty, Cast Iron, Bearing and Spacer Constructed, Setscrew Lock, Contact and Flinger Seal, For Use on Vertical Adjusting Screw Air Actuators