AMANA 168374 OEM Upgraded Replacement for Goodman Furnace Flame Sensor

FLAME SENSOR

This is a genuine replacement part for an Amana Furnace. It is the Flame Sensor for an AMANA Model HFD08XW2D and other models listed below. One of the most common furnace problems is a failed flame sensor, both on gas furnaces and on electric furnaces. Most of the time when the furnace stops working, it is because the flame sensor has been overworked due to being clogged or dirty. When this happens, your furnace won't be able to

This DENSO flame sensor is a genuine OEM replacement sensor for the Amana brand of furnace. This Flame Sensor is designed to detect the inrush of natural gas when you turn the thermostat up to MAX and allow the furnace to fire much faster than normal. This will save natural gas money from being wasted due to excess heat loss between cycles. This Denso Sensor has High Performance Properties such as Lower Power Consumption, Less Noise Level, Quicker Starting Capability, Small Duty Cycle and easy installation

This OEM Upgraded Replacement Flame Sensor is brand new and comes in an open package. It is 100% tested before leaving the factory. The flame sensor that is used in furnaces does not require any plumbing connections. It simply clips onto the gas supply line. When the flame goes out, the gas valve either trips or shuts off to prevent gas leaks that could cause a fire, and to prevent gas from running into your home.

This must be the part you are looking for to fix your furnace troubles. This is a brand new, OEM, upgraded replacement for Amana furnaces. This is a flame sensor # that detects open flame with heat and light sensors. This sensor has two main functions: To monitor the status of the burners; and to provide feedback to the thermostat that controls the burners, thereby, modulating the burner output based on sensing of the flame (heat) at its ports. If your

Replacing the sensor is one of the most common furnace repairs. Failure to replace a defective flame sensor can result in the furnace shutting down, and if not diagnosed properly, can lead to other issues with ignition or system operation.This flame sensor is compatible with select Amana brands models and replaces Part number AMAN4125208.

The flame sensor may be a standalone component on older furnaces. If you can't find the correct flame sensor online, call your local heating specialist for help getting it. Make sure he is correct about the replacement part. Install the new flame sensor in exactly the same place and orientation as the old one. _____ Sears 1027931099 RANGE KITCHEN SUPPLY REPAIR PARTS _____ ACCESSORIES ________ ` Clamps ` Ovens are fairly simple

Replaces the original flame sensor on many units. Easy DIY installation with basic hand tools. The flame sensor has been upgraded for longer service life and a longer plating process is used to prevent corrosion.