CALVAN ALSTART CV91800 Rear Axle Bearing Puller

Rear Axle Bearing Puller

This Professional Grade Rear Axle Bearing Puller can be used to remove and replace the entire axle assembly on a vehicle. It has a huge 10mm nut on one side that is used to "peel" off the old axle assembly and a threaded 12mm hole on the other side that allows for easy removal of the new axle assembly. This tool will save you tons of time and money when compared to having your local shop do the job for you.

Get the job done fast, safe and easy with this economical rear axle bearing puller set.

The CALVAN ALSTART CV91800 Rear Axle Bearing Puller is a professional quality tool for removing the bearings from VW vehicles equipped with 6 bolt axles. Works on all VW cars 1980-14. Featuring hardened and precision ground jaws that pull in sync to eliminate movement and binding while pulling, while adjustable jaws allow extra clearance for deep rear bearings on 6 bolt axles. One jaw is designed to pull the bearing in either direction, using a 50mm (2") hex-shaft socket or a standard 1/2" drive ratchet.

The CALVAN ALSTART CV91800 Rear Axle Bearing Puller is ideal for servicing the rear axle of your vehicle, making it easier to install and remove wheel bearings. It features a high strength, zinc-plated steel casing that is resistant to rust, corrosion, and impact. This will help make sure the product protects your wheel bearings from any kind of interference and allows the bearings to last longer. The high-grade plastic slip on arms provide outstanding grip, perfect for gripping wheel bearings securely.

Easily remove bearings with this Calvan rear axle bearing puller, which eliminates the need for draining the differential. It's compatible with most makes and models of Honda, Acura, Mazda, Nissan, and Toyota vehicles.

The CALVAN ALSTART CV91800 Rear Axle Bearing Puller is made of aluminum alloy, after finished skiving cup pulls out with great convenience. It is used on vehicle's rear axle to remove the rear axle bearing cup with the puller when it is worn out. It is lighter, more convenient and fast than conventional way.

A perfect tool for removing pressed-on bearings from rear axles.

This puller is used to press out the old bearing retaining ring on rear axles when replacing the old bearings. This puller should be used with a impact wrench, such as the one found at http://www.etrailer.com/Suspension-Steering/Bearing-Pullers/CALVAN-1743050.html . It has a ratchet head that fits over the inner hub of the axle and two semi circular rings for pressing against the inside of the bearing race.

Take this toolbox essential along on out-of-town trips to help get your car back on the road in no time. Simply slip this puller over the axle, yank on the handle, and watch as it separates with ease. The high-quality steel construction makes it perfect for both professional auto mechanics and weekend do-it-yourselfers alike.

The easiest way to remove that nasty half-axle nut without damaging the axle housing. Fits 30 Spline axles from a '85-'06 Jeep Wrangler & TJ.