Printed Defrost Circuit Board
A Printed Defrost Circuit Board
Prevent your Carrier air conditioner from overworking with this Replacement Defrost Circuit Board. It features a printed circuit board designed not to crack if moisture builds up on it. Get rid of annoying beeping sounds and the flashing issue of your air conditioner and install this Replacement Defrost Circuit Board.
The product is a defrost circuit board for certain Carrier dehumidifiers. The circuit board has been engineered to the highest standards of quality and reliability and is prone to leak at the drain tube clamp should it be damaged during installation or servicing.
The DEFROST circuit board is a genuine Beko spare part.
The circuit board controls the defrost cycle for Carrier heat pumps and air conditioners. This board is located in the unit and mounts inside a case that is accessible by removing the panel.
When the refrigerator goes into defrost, the frost in the evaporator coil or at the bottom of the refrigerated sections melts and flows out of the refrigerator over a period of time. A temperature-sensitive bimetal in an automatic defrost control device attached to the evaporator coil senses when enough frost has melted to reduce the temperature of the air at this location to that sensed by the bimetal. When this temperature differential occurs, the automatic defrost control device directs power from the main control board (MCD) to other parts of the defrost system enabling them to carry out their functions.
The HK32FA006 is a 30.00in wide, 36.75in deep, 19.00in high KitchenAid refrigerator with automatic defrost, manual temperature and ambient humidity controls, and a bottom-mounted compressor with electronic controls. The refrigerator comes with a door alarm that alerts you if the door has stayed open too long, or has been left open during defrost; it also has a water dispenser that delivers pure filtered water and ice directly to your glass.
Free Shipping
In stock
