CARRIER LH33WZ003 LH33WZ003 FLAME SENSOR ELECTRODE FLAME SENSOR ELECTRODE

FLAME SENSOR ELECTRODE

The LH33WZ003 Flame Sensor Electrode provides the flame-detecting function for gas water heater models LH33. It is suitable for use with all manufacturer and make gas water heaters in the USA. Gas water heaters with pilot are not auto ignition, pilot is needed to ignite burners. Upon detection of flame failure, microprocessor activates error indication signals.

This flame sensor electrode is designed for use with Carrier heating equipment. This flame sensor electrode replaces a No. 2 Yvonne, compatible with most gas and oil furnaces in the U.S.

The Flame Sensor Electrode helps to regulate and stabilize the flame in gas ranges by providing a flame signal. It must be installed via thermocouple wire.

Built with Liberty's 25 years of experience, the LH33WZ003 Flame Sensor Electrol...

Electrodes are used in conjunction with flame sensors to help prevent ignition of the gas within the equipment.

The LH33WZ003 Flame Sensor is used on Carrier gas furnaces and heat pumps using flame detection, including the following models:

When replacing a flame sensor, note the part number on the printed circuit board by the heating element and compare it to the part number of the new flame sensor. Our flame sensor is designed for use with Carrier® gas furnaces with a flame sensor connector (PT103, PT231, PT321, PT523).