COLLAR LOCKING NUT for Hobart - Part# 00-071311

COLLAR LOCKING NUT for Hobart - Part# 00-071311

The COLLAR LOCKING NUT for Hobart - Part# 00-071311 has a rating of 3

The AllPoints solution for replacing the Collar Locking Nut for Hobart

A collar locking nut is a lockwasher with two reinforcing locking tabs

Simply install in place of the standard collar nuts and tighten with a wrench

They are used in the same manner as a standard lockwasher, but they provide additional tightening and sealing force to prevent loosening

As it is secured by a hex bolt, the Collar Locking Nut makes it difficult to remove

Vulcan Collar Locking Nut for Hobart Mixer 00-071311 should be used with rubber washers on each piece of equipment

These collar locking nuts will fit your Hobart mixer

The locking nut is needed when adding a pre-threaded spout to a Hobart mixer

This will prevent the collar from slipping off during operation, which can cause damage to the motor and possibly result in serious injury to you

The Hobart Collar, Part # 00-071311, is a replacement Collar Locking Nut

It is designed to secure the bowl, drive hub and flat beater assembly to the motor shaft

This is a NEW Collar Locking Nut that fits some Hobart mixers

The COLLAR LOCKING NUT for Hobart - Part# 00-071311 is in the Fasteners & Hardware category

2 out of 5 by 2

The tabs are placed between the head of the fastener and the clamping surface to be sealed

Collar Locking Nut for Hobart - Part# 00-071311

The Collar Locking Nut can be used in any application where safety is a concern

This collar locking nut features an allen wrench hole for removal and tightening along with a keyway for servicing the machine in the future

Vulcan Collar Locking Nut for Hobart Mixer 00-071311 is a direct replacement part and fits under the mixer head

Fits Hobart Models:

The Hobart Collar Locking Nut is used in conjunction with the Hobart Multi-Collar Clamp to prevent the collar from moving on the cylinder