CUMMINS (ONAN GENERATORS)
CUMMINS (ONAN GENERATORS)515-3004947 REMOTE CONTROL PIGTAIL HARNESS
This is a remote control pigtail harness for Cummins (ONAN) generators. It allows you to operate the generator from a distance.
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountREMOTE CONTROL PIGTAIL HARNESS
CUMMINS (ONAN)285-05914 REMOTE CONTROL PIGTAIL HARNESS
CUMMINS (ONAN GENERATORS)515-3004946 REMOTE CONTROL PIGTAIL HARNESS. This is a Brand New Aftermarket Replacement Remote Control Pigtail Harness for the above discontinued engine controller generator set. The pigtail harness is 10 ft. long and will need to be spliced to any length. The harness fits Cummins Onan 15 kW, 17.5 kW, 18 kW, 20 kW, 21 kW, 22 kW, 30 kW and 31 kW gasoline generator models with a 2 conductor Remote Control pigtail connector mounted on the control panel or separately from the control panel
The CUMMINS ONAN REMOTE CONTROL PIGTAIL HARNESS is used on several ONAN portable generator models. It facilitates remote control of the generator's built–in transfer switch without needing to wire between the control panel and the transfer switch.
The Remote Control Pigtail Harness allows for easy hook-up of the remote control harness directly to the generator. No permanent install is required and can be reused many times. The Remote Control Pigtail Harness is a generic wiring pigtail designed for use with remotely controlled ONAN generators only and should not be used with other makes and models or generators that do not comply with ISO2304-1:2001 & ISO2304-2:2001 specifications.
Onan Remote Control Pigtail Harnesses are designed for use with Onan/Cummins generators and automatic transfer switches (ATS), and come in a variety of different shapes and sizes to match your needs.
This pigtail harness is designed to supplement your existing remote harness and control box assembly for the following models: 500KW, 520HPQLM, 560HPQLM, 600KW, 630HPQLM; portable C200; portable C250; portable C300; portable C500.
This pigtail harness is used on all Cummins Onan generators with 110v remote controls. __The remote control harness is electrically and mechanically compatible with all of the Cooper Power systems remote control assemblies.
This pigtail harness wire assembly is a replacement part for the circuit board used on some models of portable Onan and Cummins generators. This includes model numbers: C28500, C28500A, C29000, C29000A, and C39000A. Used in conjunction with the 1584-MA41 remote control harness, this harness will allow you to replace or repair your cables that connect your generator to your control box.
Prior to 1987, auxiliary power connections were installed on the spark-plug side of the generator. On applications where generator power is routed to a control panel or other location on the dash, this pigtail harness is required. This pigtail harness consists of a 4 inch harness with three receptacles and three terminal screws.
A new pigtail allowing for early battery disconnect
The Cummins (ONAN) 515-3004946 harness is designed to transfer signals between the generator's control panel and the main board so that the electrical systems on the generator work correctly. This harness also connects to an external key switch located on the generator.
Home and Mobile Generators: Allows easy installation of a remote control pad under dash or in engine compartment by using pre-existing power cords.