EATON C320TP1 Cutler Hammer- .1-30sec PNEUMATIC TIMER NO/NC

.1-30sec PNEUMATIC TIMER NO/NC

The Cutler-Hammer® C320TP1 series 24VAC .1-30 sec Pneumatic Timer No/NC (Without Neutral Required) is used on practically all types of centralized control power distribution systems. This product is fully potted for thermal protection and has an end of line resistor function. Use this .1-30 Sec Pneumatic Timer No/NC (Without Neutral Required) with high speed motor control to prevent motor damage from short cycling.

The Eaton C320tp1 .1-30 sec Pneumatic Timer No/nc, is a timer for pneumatic control of lighting, heating and air conditioning, process instruments, recording devices that have to be turned on/off at predetermined times.

The Eaton C320TP1 Cutler Hammer NO/NC .1-30sec Pneumatic Timer features photoelectric terminals, manual reset, pneumatic actuator and magnetic limit switch. These timers help reduce motor burnout, restart cycling times and maintain motor speed, as well as providing longer equipment life and higher system efficiency. The C320TP1 Cutler Hammer is a timer that will have your paint system purring like a kitten.

Standard PNEUMATIC TIMER NO/NC is used on the load side of the motor starters to limit the length of time the starter remains energized.

The C320TP1 is a single function, air-powered timer control designed to interface with pneumatic power sources. This electronic pneumatic switch features a 300 watt, SPST, time delay relay and operates over the temperature range of 0 to 125°C. The inductive pickup required .3 to 3 amps of inductive current from 10 to 30 volts d.c. The output of the switch was SPDT (2 pole) NO/NC (normally open contacts) ___

324T Series timers have a 2%-40% faster response time than standard pneumatic timers, and the time delay is 2 to 30 seconds. Ideal for use in residential and light commercial applications where appearance is important.

This C320TP1 Eaton Cutler Hammer Timer Switch with Pneumatic Time Delay (4000 Series) is a single, 1-phase, snap-acting time delay that acts as a solid state release element when energized. This timer can operate both normally open or normally closed contacts.