Detroit Radiant MARK10DX-117 Re-Verber-Ray MARK10DX117 Circuit Board, 120 Volt

120V Ignition Module

Detroit Radiant's MARK10DX-117 Re-Verber-Ray MARK10DX117 is a 120V Ignition Module. It has 10 Channel Relay Outputs, and 3 relay control outputs, and can handle 17A Max Per Channel.

The Re-Verber-Ray MARK10DX117 is a replacement 120V Ignition Module for the Detroit Radiant Mark 10DX Series Pumps.

The MARK10DX-117 is a 120V Ignition Module with a 15 amp/277 volt coil. It can be used to retrofit older Mark 10, iMark5 and EHW series heaters to replace the old 50Hz coil modules with the new 50 or 60Hz coil modules.

The Detroit Radiant ReVerber-Ray 120V Ignition Module is for use with Detroit Radiant Series 6, 8 and 10 Kilowatt Electric Water Heaters. Replaces part numbers MARK10DX117, MARK3DX117 and MARK6DX117.

The MARK10DX-117 Ignition Module, is a 120 volt ignition module used, on some Detroit Radiant Reverberation Ray Heaters. Using a two line plug the Voltage V6170517, part number 01249-00-X01 and the Ignition Module CONTROL MODULES V6390012, both listed in the replacement parts section of this web site.

The Detroit Radiant MARK10DX-117 Re-Verber-Ray 120-Volt Ignition Module, Mark 10 DX Circuit Board is a replacement module for the Mark 10DX. It's measures approximately 6 0/16 inches long by 2 5/16 inches tall by 1 inch wide and has a Unique 11 slot design.

The Detroit Radiant Re-Verber-Ray MARK10DX117 Ignition Module with Lobe is ideal for residential and commercial applications. It provides direct drive ignition for both an inducer and a turbine blower; operates on 120V, 60 Hz power source, and provides up to 10 kW of capacity to connected equipment.