Lisle LIS59530 Extension Handle for Pinion Bearing Race Driver Set

Driver Extension

Adding approximately 10-1/2 inches to the driver handle, this extension is intended to be used as factory intended.

When servicing the pinion bearing on a front-wheel drive vehicle equipped with a limited slip differential, it is often necessary to stand on the floorboard to apply enough pressure. If this is your situation, then the Lisle 59530 Pinion Bearing Driver Extension Handle is for you!

I have a complete set of deep pinion bearing race drivers, yet, I needed just a little more driver handle. So I went back to Lisle and bought this 5.50 inch extension handle for the little pinion drivers and now my work is much easier.

The Lisle Extension Handle is a quick and easy addition to your Pinion Bearing Race Driver Set. The handle extends a full 14" for better control and more leverage when removing even the toughest bearings. Includes 3/8" drive extension shaft, 10mm hex, and 1/2" drive adapter. For better leverage and control when removing stubborn pinions, it's perfect.

Fixes the end of the drive handle for Power Pinion Bearing Driver set #LIS59520 to accommodate 2" diameter sockets. Helps reach tight spaces with ease. Fits current model 6-way and 8-way long handles."

The Lisle 59530 is an extension handle for the pinion race driver set. This extension handle can help while removing or installing a bearing in a vehicle.

Extends the length of the Pinion Race Driver easily to make it easier to remove pinions from the backing plate.