OTC OTC-6695 Axle Shaft Seal Installer for Ford 1998-2004 F-250/350/450/550.

Ford Axle Shaft Seal Installer

Med Corp has been manufacturing high quality aftermarket parts for years, and now you can get your hands on their OTC-6695 Axle Shaft Seal Installer for Ford 1998-2004 F-250/350/450/550! It comes with a full manufacturer warranty and is guaranteed to fit your vehicle's needs

The OTC-6695 is designed for use with the 9" or 10" seal remover (sold separately), which is used to remove the outer axle seal from the stud end of the axle

This axle shaft seal installer is designed to make a tough job easy

This Axle Shaft Seal Installer Tool will make this job a lot easier for you

The tool kit includes a drill adaptor for use with powered drills and a ratchet handle for use with manual drills

The OTC-6695 is designed to remove these seals without destroying them for future repair

Ford 1998-2004 F-250/350/450/550 OTC-6695 Axle Shaft Seal Installer

If you're in the market for a Ford Axle Shaft Seal Installer, then look no further than OTC-6695 by Med Corp

When this happens, the seal may leak and cause damage to the axle or differential

One of the most irritating parts about swapping axles in your truck is dealing with the axle shaft seals

Two rubber plugs are used to prevent dirt and water from damaging the axle shafts, however these plugs can be damaged

It's simple design allows it to be used with a standard 3/8" drive ratchet and extension

A common problem found on the Ford super duty trucks, this tool will save the technician time and money by eliminating the need for a seal puller

OTC-6695 Axle Shaft Seal Installer for Ford 1998-2004 F-250/350/450/550

Axle Shaft Seal Installer installs the factory installed axle shaft seals on the Ford 1998-2004 F250, F350, F450, and F550 Super Duty Trucks

The OTC-6695 Axle Shaft Seal Installer is designed to install seals onto axle shafts on Ford trucks built from 1998-2004

This tool is designed to remove and install the axle shaft seal on the Ford F250-450-550 Super Duty(1998

This tool is designed to make it easy to install or remove the rear axle shaft seals on Ford F250-550 Super Duty trucks from 1998-2004

The 5" extension can be attached to provide additional reach for vehicles with deep wheel wells

The OTC-6695 installs both front and rear axle shaft seals

This tool is designed for the removal and installation of axle shaft seals on Ford trucks using a 3/4" drive ratchet

Ford Part #: 3C3Z-6695-EA

This tool is specifically designed to work with Ford 1998-2004 F-250/350/450/550 Super Duty Trucks and will make installing new or used seals a breeze!

This tool is built with two threaded ends to fit all seals on any model from 1998-2004 F-250/350/450/550 Super Duty Trucks

This tool allows you to temporarily remove your axle shafts to change out seals and bearings

These will cause you lots of headaches, as they only fit in one way and can get stuck if you don't do them correctly