AMANA 2480692 - Amana OEM Furnace Replacement Limit Switch L240

GOODMAN OEM FURNACE REPLACEMENT LIMIT SWITCH, L240| Manual Reset Limit Switch

The Goodman OEM Furnace Replacement Limit Switch, L240 is an easy-to-install thermal safety device that protects the furnace from burnout if excessive heat is generated in the flue. The Limit Switch is activated if the excessive temperature remains for more than 4 seconds and interrupts power to the furnace until reset (by depressing the push button on the switch)

The Goodman OEM furnace replacement limit switch, L240 is a quick acting limit switch that is used to limit the temperature or excess current in a furnace. When the power fails or the limit control becomes defective this part must be replaced immediately.

The Goodman OEM Furnace Replacement Limit Switch, Part No. L240 by Goodman is designed to control the operation of a heating or cooling system. The limit switch is an integral part of the blower assembly. This kit contains a limit switch and internal wiring harness, which enables you to install the new component quickly and easily.

The Goodman OEM Furnace Replacement Limit Switch is designed to replace one that has failed and operates the blower. It includes an over temperature limit, a manual reset and a low voltage that is factory preset at 48 volts.

The L240 Limit Switch is used to help ensure the furnace burns safely and efficiently. The L240 Limit Switch should be replaced if it is not working properly or has failed. If you are not sure if this is the correct part for your model call a Goodman authorized installer to find out.

Comes with 3 pin plug and wire pig tail configurations. Goodman® Limit Switch is the original equipment manufacturer replacement part for almost all furnace brands and models.

The 2480692 limit switch installs on the exhaust duct elbow to indicate when the flame sensor is covered by fresh air. This Goodman limit switch uses a thermal cut-out to stop the gas supply to the gas valve when a short cycle is detected. Each limit switch includes 3/8" male threads on both sides of the body for easy installation.