HIGH LIMIT SWITCH for Crescor - Part# 0848 060

HIGH LIMIT SWITCH for Crescor - Part# 0848 060

The High Limit Switch is an important safety component of Crescor and is used to ensure that the temperature rises no higher than 136°C. When temperature reaches 136°C, the high limit thermostat will turn off power to the heater.

The HIGH LIMIT SWITCH for Crescor - Part# 0848 060 is a switch that is used in conjunction with the Crescor unit to avoid overfilling of lines. The HIGH LIMIT SWITCH for Crescor - Part# 0848 060 is located outside the tank and detects when the tank has reached its maximum fill level. When this occurs, the HIGH LIMIT SWITCH for Crescor - Part# 0848 060 will turn off the pump.

HIGH LIMIT SWITCH for Crescor - Part# 0848 060

The HIGH LIMIT SWITCH for Crescor - Part# 0848 060 can be used to detect if the temperature exceeds the set point. The HIGH LIMIT SWITCH for Crescor - Part# 0848 060 is a fast response switch with a built-in thermal fuse.

The Part# 0848 060 HIGH LIMIT SWITCH for Crescor was designed to ensure that the Crescor continues to operate in the presence of a fault. This is accomplished by activating the Crescor circuit breaker if a fault condition is detected. The unit is housed in a durable metal enclosure with clearly labeled terminals.

The Crescor® High Limit Switch is used in combination with a Crescor® Thermostatic Valve to prevent damage caused by excessive water temperatures. The design of the Crescor® Thermostatic Valve utilizes two stainless steel thermostats and non-contacting switches to prevent excessive gas temperatures. These switches are located in the cold and hot water lines, one at the heater and one near the boiler. If either thermostat opens because of an excessively hot or cold condition, then these switches open causing the burner to shut off.

The Crescor High Limit Switch for Crescoin Operated Power Cords is designed for use with the Crescor II power cord. This switch is suitable for use in accordance with most electrical codes. It is intended to provide circuit protection to the motor and device by interrupting the current flow when excessive current conditions exist.

The High Limit Switch is designed to operate in the presence of a high voltage, high current fault condition and to interrupt the circuit when the current exceeds the set value. The High Limit Switch protects equipment from catastrophic failure due to inadequate protection or damage. The device can be used with an electrical appliance or power tool that has a short circuit fault in its internal wiring, causing a high amount of current flow through the wire. This switch can also be used for non-fault applications, including general purpose applications where overcurrent protection is desired.

Crescor™ is the world’s first temperature-controlled water heating system. It uses a patented, high-efficiency technology to heat water to any desired temperature and maintain it there independently of the source. Unlike tankless electric boilers, Crescor needs no expensive installation or venting, no dedicated electrical circuit and can be located almost anywhere indoors where water is needed for comfort, sanitation or productivity.

HO848-060 (HIGH LIMIT SWITCH) is a replacement part for Crescor, the leading manufacturer of residential and commercial wall ovens.