Honeywell 40003916-026 24Vac 50/60Hz replacement head for V8043E with end switch

V8043E PWR HEAD

Installation, Replacement and Configuration of a V8043E PWR HEAD. The following interfaces are to be completed in order to configure the replacement head. Connector. End switch assembly with float. Programming Keypad. Ambient Light Sensor (ALS). The V8043E PWR HEAD is shipped from Honeywell with the end switch unpopulated, the water sensing float and programming keypad not installed and the ALS and connector properly configured for local voltage in accordance with the configuration documentation shipped with it.

The V8043E PWR HEAD operates the V8043E pressure switch, which controls airflow at the high pressure side of a heating or cooling system. The V8043E has been replaced by the V8043S, which is identical to the V8043E except that it does not have an end switch (non-end swtich control arrang

A replacement head for the V8043E includes an End of Line (EOL) termination for easy installation of an end of line resistor. This six-wire pwr head has a NEMA 6-20P plug with 10 in (254 mm) long leads and built-in strain relief. It is made with screw terminals and supports up to eight 16Amp conductors.

The V8043E powerhead is ideal for applications where high flow and low pressure are required.  Can be used in lawn and garden products, water filtration, pool/spa, commercial sanitation and more. The V8043E is a self-contained unit that includes a powerhead, end switch, check valve and mounting bracket.

The V8043E replacement powerhead is designed for use with the V8043E and V8045E Variable-Torque drives. This powerhead can be used for either variable-torque or fixed-torque applications.

Add a replacement head to your V8043E system with the 40003916-026 replacement head. This unit comes equipped with a manual end switch and includes 6 ft. of power cord for direct replacement.

The Honeywell V8043E plug-in occupancy-sensing fan control is a single-pole, four-wire, contactor type, leading edge, reversing switch designed for fan and lighting loads where timed automatic on and off switching or time delay flash switching is required. A built-in microprocessor provides the intelligent logic of this unit; therefore, a separate timer is not necessary.