Honeywell 4074EDJ TestPlug & 3 Resistors for W7100 TestPlug & 3 Resistors for W7100

TestPlug&3 Resistors for W7100

TestPlug&3 Resistors for W7100

The TestPlug&3 Resistors for W7100 are designed to trigger Low Voltage Transient Protected systems and measure Short Circuit Current. The plug simultaneously delivers both a 3-amp 60 Hz, 240 volt AC (or higher) test signal and a 1.5 amp 40 to 100 Hz, 120 volt AC (or higher) test signal with a battery. This saves time since the device being tested need not be cycled through the entire power range of the tester.

This TestPlug&3 Resistors for W7100 can be used on your "W7100 with Electric Drain Pump" and other brand vacuum cleaners until item number 4074EHDNZ What you will receive:  1 W7100 TestPlug 2 300 Ohm Resistors 1 600 Ohm Resistor

The Honeywell 4074EDJ TestPlug & 3 Resistors for W7100 are used to test or replace an existing 4074R, 4078R, or four 2876R (tested by the HP8500A) hot terminals.

The Honeywell 4074EDJ TestPlug and 3 Resistors for W7100 is a test plug and three resistors for use with the W7100. This plug and resistors are also applicable to the following models:

The TestPlug is a diagnostic device that helps troubleshoot portable generators. Used in conjunction with the Honeywell W7100 generator, it is designed to help you eliminate unnecessary service calls and decrease costs. The TestPlug includes three resistors for testing start current, overcurrent protection, and phase rotation.

The Honeywell W7100 is an excellent multi-functional thermostat designed to satisfy the home comfort, oil heat needs. Each unit requires a Test Plug connection for daily diagnostics. This plug has to be either hard wired or plugged in each day to the W7100 thermostat. The three additional resistors are included should your programming require them.