Honeywell 2039 C554A1794 PhotoconducFlmDetec E TYPE BKT PhotoconducFlmDetec E TYPE BKT

FLAME DETECTOR W/30" LEADS E MTG. B

The 2039 is a Flame Detector with 30" leads for easy installation. The detector has a steel enclosure and a visible alarm status. It can be wall, table, or ceiling mounted. The unit has E, MTG and P-touch label options.

This Flame Detector is a photoelectric type flame detector with a large lens and an open space behind the detector for easy viewing. It can detect flames from natural gas, propane, kerosene, etc. This flame detector features 30" leads with 12" tail wires and comes with mounting brackets for easy installation.

Detect flame failure in the instant that it happens! Attached directly to your furnace or gas range with 30" leads. Reduced sensitivity for safety ** Application: Commercial & Industrial Furnaces.

Vibration-resistant housing Flame-detecting devices, built into a variety of models of portable gas detectors and widely used in the petrochemical industry, warn against impending ignition sources. The actual sensing element is a photoelectric device, which is housed in a vibration-resistant case. This drawing illustrates a typical flame detector unit with 30"-long leads for mounting on external piping. A typical installation provides protection for a 2- to 4-in. pipe as well as small tanks and storage

This flame detector has a 30" wire lead and is designed for ceiling, wall, or floor mounting. It features a base-mounted switch with green LED verification, a photoelectric sensor with concentric tube lens assembly and four red LED indicators. The tamper proof cover screws onto the threaded base to maintain a dust free environment and prevent tampering. This flame detector also offers direct closure of the unit without the need for door removal or time delay.

Flammable gas detector mounts to pipes or walls with built-in bracket. Flame-detector circuit monitors all fires in flammable gas areas and sounds audible alarms in a control panel. It can be mounted on posts, vaults, storage tanks and flues for protection against the sparking or spontaneous combustion of fuel vapor, vapors from alcohol or similar substances in use or storage.

The Honeywell 2039C554A1794 Flame Detector is designed to measure and alarm in the event of a high temperature from a flaming fire. The photoelectric cells contained in this detector automatically respond to radiant energy even through smoke. This flame detector features two, independently operating photoelectric cells and must be mounted vertically. The Honeywell 2032A270 Flame Detector operates independently of ground fault circuit interrupters (GFCI). An alarm sounds if either cell in a detector is weakened