Honeywell MP909E1513 The Spring Range Pneumatic Damper Actuator

9-15# S/R DAMPER ACTUATOR

The 9-15# Series of Pneumatic Damper Actuators are designed to control a wall or floor register opening. The Damper Actuator can be used in combination with any Honeywell or non-Honeywell actuator (except the H9C).

The Honeywell MP909 E1513 Spring Range Pneumatic Damper Actuator is designed to control the pneumatic damper from 9-15#. It has a linear output of 0.09 in/in when used with force coil spring and its maximum output is 8 ft2 of air. This actuator is a compact and solid construction that is 2-way adjustable. The 2-way adjustment allows for air discharge in either direction by changing the settings on the input port circuit board.

The PCU MP909 Series Spring Range Pneumatic damper actuator is a line control device used to remotely adjust air flow damping on constant air volume systems. The damper actuator is designed for 5" - 10" (127mm - 254mm) duct work and can be used with return (refrigerent) or supply (heated/cooled air) systems. It consists of a pneumatic cylinder attached to a linear-moving, adjustable arm assembly which is spring loaded by means of a leaf spring return. A bump stop prevents uncontrolled movement back to the closed position and a limit switch prevents

The Honeywell Spring Range Pneumatic Damper Actuator, part number MP909E1513, is designed for a wide variety of applications. It is commonly used in heating and ventilation systems. The unit provides the ability to open and close dampers and registers using pneumatic pressure. The diameter of the damper-actuator shaft is 1/4 inches.

The HONEYWELL Spring Range Pneumatic Damper Actuator is used on both Section Return and Standby dampers.

The Spring Range Pneumatic Damper Actuator, for Tri-Tronics Spring Range transmitters, attaches to the supply and return air ducts to modulate their temperature based on user inputs from a programmable controller. This damper assembly opens the ducts when the temperature is below 50 degrees or above 90 degrees, closing them when setpoint temperature is reached.

Honeywell's Spring Range Pneumatic Damper Actuator is designed for use with contoured windows. The damper actuator has an operating pressure range of 25-125 PSI. The devices operating pressure is adjustable via the external adjustment screw. The polished brass output shaft extends 15/16" and operates using a concentric spring.