Honeywell ST9103A1002 Replacement Electronic Fan Timer for Oil Furnace Applications

"ELECTRNIC FAN TIMER

For use as a replacement timer to control oil fired furnace and/or air handler units. The ST9103A1002 is compatible with most standard timer-switch and limit-switch wiring systems.This low voltage, high power electronic fan timer may be ordered to replace non-functioning or damaged in-wall timers. Features include single pole double throw switch with normally open contacts that will control a two wire variable speed, reversible motor (120 volt AC or 240 volt AC), Electromagnetic 8 hour on/16 hour off function, this timer will turn the furnace fan on for 8 hours and off for 4 hours.

The Honeywell ST9103A1002 simple to operate electronic fan timer is a factory-set replacement for the following furnace timers: * NorthStar 1 to 60 minute electronic fan timers * Armstrong 1 to 60 minute electronic fan timers * Avcon 1 to 60 minute electronic fan timers * Burnham 1 to 60 minute electronic fan timers Features: Energy-saving technology with daylight savings time (DST) and setback capability, Industry compliant for use with most oil-fired, Hot Water (Hydronic Heating), Heat Pump and Steam Boiler applications, Primary or secondary burner control for fireplaces or heaters, Easy installation.

This Emerson/Honeywell Model ST9103A1002 electronic fan timer is used in forced air furnace applications to control the speed of a blower fan. When installed in a properly sized circuit, this replacement timer meets the UL508A standard and can be used with other electronic controls.

The Honeywell electric fan timer controls your furnace and fan - features 3-output options (heat, cool, fan) for oil/electric furnaces. Replaces older models 518B10035A and 415A10035.

This electronic fan control is used for oil furnace applications that require a 24-hour schedule. It can be programmed to run the fan continuously, alternating between on and off times, or it may be set to run only during non-heating hours. It has a low voltage plug with a 6' cord. The timer is a 10 amp/120 VAC 4-wire board mounted unit."

This three-position fan timer fits most oil furnace applications. It includes an 8-hour automatic on/off fan shutoff and a backlit LCD screen. Controls one electric fan or blower.

This product is intended to control the run time of an electric fan in an oil furnace application. A time delay range of 48-90 minutes is provided, however, this is a limit only and the timer can be set to any value within this range.