Honeywell ZD20X16TZ 20L X 16H Parallel 2pos24v S/R

20L X 16H Parallel 2pos24v S/R

This 20L X 16H Parallel 2pos24v S/R remote wall switch uses the latest solid state (LSI) switching technology available. A solid-state device is a form of semiconductor circuit that uses no mechanical parts and has no moving parts to wear out. This switch replaces a 24VAC, 4 Amp double pole single throw remote control which must be operated with a mechanical push button actuator. The HONEYWELL ZD20X16TZ 20L X 16H Parallel 2pos24v S/R has many advantages over conventional switches including:

The Honeywell ZD Series 1/6 hp, 20 L x 16 H, Air Sweep Parallel 2 pos/ 24 volt S/R motor is used to remove contaminants from workplace air as a direct replacement for the ZR Series 1/6 hp, 20 L x 16 H, Air Sweep Parallel 2 pos / 24 volt S/R motor. It has a sealed rotor and Overload Protection. It features a VA Class F insulation and a Class B Shaft. It meets ASHRAE Class IIA at 115 VAC / 60 Hz and Class II at 230 VAC / 50 Hz. The motor is belt

The Honeywell ZD20X16TZ (20L x 16H Parallel, 2-position, 24V DC) is a fixed speed drive with thermally protected motor that features permanent magnet operation, double insulated copper windings, shielded bearings and an integral test circuit.

The Honeywell ZD20x16tZ 20L X 16H 2-Position Double Parallel (Up And Down) Heater is a 20,00 btu/hr forced air propylene gas heater. This unit offers convection and radiant heating with hot air circulation for rooms up to 1000 sq ft.

This Z-Connector is a parallel 2-position switch module designed for use in the Honeywell Enviracare II system. The Z-Connector is used with level sensors and limit switches on door interlock systems, and HVAC systems. It mounts in a standard cutout using two screws.

The ZD20X16TZ series are dual-position, snap-action switches used for normally open and normally closed circuit applications with the standard push button actuator. The switch can be mounted in vertical or horizontal positions.

The ZD series distributor transformers are designed to convert single phase voltage into 2-phase for driving induction motors. The ZD transformer can be supplied with secondary voltages of either 24, 36 or 48 VAC depending on the power rating required. The output turns are supplied via high flexible terminal blocks to ensure a good electrical connection.