Hydrolevel 4566 VXT120 Automatic Water Feeder for steam boiler 120V

120V WATER FEEDER FOR STEAM BOILERS WITH DIGITAL C

The Hydrolevel 4566 VXT120 is an automatic water feeder for steam boilers with digital controls operating at 120 volts. It can be mounted both above and below the boiler to provide up to 1/2 gallon of water per hour through up to 6 connected hoses. The feeder provides a high quality and consistent water output while reducing standby water temperature and save valuable time.

Automatic Water Feeder for Steam Boiler with Digital Control (Also available in 230 V)

This automatic water feeder is for use on steam boilers with digital controls. It attaches directly to a supply line and automatically delivers hot water when a building's hot water demand exceeds the boiler's output.

The Water Feeder VXT120 Automatic for steam boilers is a 120V water feeding device. It automatically delivers both hot and cold water to selected faucets, serving simply as a water transfer mechanism. The VXT120 will deliver 1.5 gallons every minute.

The HydroLevel® water feeder automatically delivers fresh water to the boiler, continuously maintaining the proper water level. The VXT120 is easy to install on any size steam boiler within the recommended range of 200 to 4000 lb³. It weighs less than 20 lb and can be set up in minutes. The unit operates on 120V (60Hz) electricity and incorporates two float ends that sense low water level and signal an alarm when it occurs. A microprocessor-based electronic control limits the minimum

The compact Hydrolevel 4566 VXT120 automatic water feeder for steam boilers prepares the heating system when needed and monitors its correct operation. This steam boiler accessory is used with components from most existing manufacturers, and is programmed to work with specific pressure switches, reducing installation costs. The unique viscosity switch makes it easy to adjust the setting for various cold-water or hot-water systems.

Simple to install, easy to operate, and ensures constant water supply for your steam boiler at all times. The Hydrolevel has a built-in flow switch that turns water on when the level in the tank gets low. When the water level rises it turns water off. The control panel is located on the front of the feeder so you can program the ON/OFF cycle as needed. The standard feeder model comes with 3/4" NPT inlet thread (female) and outlet thread