12Vdc DPDT 10A GenPurp Relay
Key features of the IDEC RH2B-ULDC12V 12Vdc DPDT 10A GenPurp Relay include: suitable for control applications, where excess voltage and current are not a problem, such as hydraulic power units, hydraulic oil pumps, elevators, and medical equipment. Has over-current protection to protect from short circuit. For use on circuits with constant voltage and current; has isolation outputs that do not need to interface with any load resistance, resistors or other devices.
Not critical for the IDEC RH2B-UL DC 12V 12 Vdc DPDT 10A GenPurp Relay to be written in an informative and technical tone. The most important thing is to have a product description that speaks to your target customer.
Looking for a relay that can handle up to 10 amps? Look no further than the RH2B-ULDC12V from IDEC Relays. This DPDT 10 amp relay features ultra-low drain contacts, no load power consumption, and polarity protection, so you can count on it time after time.
The RH2B-ULDC12V relay box houses three UL Listed relays with zero center detent. The RH2B-ULDC12V relays provide efficient switching of low power devices with output ratings ranging from 2.7~45Vdc, 2~30Vac or 5~50VDC. The relays are rated 10 Amp, 120 or 240 VAC or VDC and contain internal protection against high level current, over-voltage and short circuits.
The IDEC RH2B is a 12 volt dc SPDT relay that is controlled by a logic level voltage. This relay features screw terminals and requires only 1.5A to operate. The contacts are rated at 5A @ 125VAC and 10A @ 30VDC, with a max load of 100VAC/10VDC at 7mA resistive. The bounce-free contacts provide a clean break and eliminate electrical noise. It is UL listed for use in commercial and industrial control systems and equipment.
The RH2B-ULDC is a 2 Form C Relay with UL DC Voltage Input Power and uses super-fast Transistor Output Drive. Its base has a mounting hole pattern 0.3" × 0.5" PC Board. The RH2B-ULDC relay can be use in control, alarm systems, and various industrial applications where control switching or power circuits are required.
The IDEC RH2B-ULDC12V relay is designed to operate DC switching applications up to 10A. This FET relay features high surge current capability and low on resistance, and has a switch life of 100,000 cycles. The relay is UL approved, designed for use in UL rated systems and has a maximum switching current of 10A.
This powerful relay can be used to control other small devices with a relay. We recommend using the relays in conjunction with a DC voltage source up to 15VDC or AC power supply of up to 128VDC.
Easy 10A switching with NO Contact Forming. Unicontact NO Forming (NCNF) contacts operate on 0.6W at 30Vac/500 Vdc, more power than competitive products. Meets UL489 and CSA 22.2 No. 1423-01.