GARLAND F12429 COMMERCIAL INDUSTRIES Ignition Control

IGNITION CONTROL

The Ignition Control is perfect for pools, marinas and other high-traffic areas with long pumping distances. It installs on the pool's suction line, reducing the time it takes to start the pump and then shuts off automatically when the appropriate level of suction is reached, eliminating the need for a water level controller. In just minutes you'll be enjoying an effortless and efficient start every time you want to use the pool.

The Garland Ignition Control gives your indoor propane appliances the safety of automatic shut off, over temperature protection, and individual burner control. The standard stainless steel guard protects the thermostat and glow tip from accidental damage, while keeping out dirt, leaves, and insects for maintenance-free protection. Tested at over 70 psi to 170,000 BTUs, this model is designed for outdoor use in commercial applications such as gazebos, raised decks and hot tubs.

Commercial Ignition Control allows you to turn off the ignition to your pool or spa. This keyless control is simple, convenient, and eliminates the need for shutting down and restarting electrical components.

When it comes to safety, only the best is good enough. The GARLAND F12429's Ignition Control Kit is certified for use in commercial applications. You can be confident that your commercial application will surpass code requirements because:

Garland F12429 Commercial Industries Ignition Control is a switch, air curtain, and mixing valve mounted in one housing. Switch controls burner ignition while four wire terminals link up to the commercial range. The air curtain directs cooking and exhaust air flow throughout the kitchen while the mixing valve delivers high output, low flame control for precise heating and simmering.

Garland Companion non-communicating dual circuit ignition control with A/C and ignition feed to engine. Fits directly to the magneto and includes a connector for the starter, cap and rotor. The rotary switch allows for selection of either the ignition or the A/C circuit. There are six settings for Ignition Control as follows: OFF ; IGNITION ; DIC (inductor current); A/G (alternator ground); AC 1 ; DC 1 (combined DC and pulse spark).

Garland Ignition Control kits are perfect for your commercial or industrial furnace system and will help improve ignition switch performance in the event of a power outage that can cause your furnace to stop running.