Johnson Controls P499RAP-101 "0-100# 1/8""pressureTransducer"

"0-100# 1/8""pressureTransducer"

The Johnson Controls Thermo Scientific 0-100# 1/8""pressureTransducer is a wide variety of ranges for measuring minute amounts of air, water or other fluids contained as part of a broader system. The transducer provides a means to convert low pressure readings from a sensor into a voltage, which can then be read on a chart recorder.

The Johnson Controls 0-100 PSI 1/8" Pressure Transducer converts pressure changes into voltages that are used for many different equipment applications. It is extremely reliable and is CE marked for use with water or gas. It can also be utilized to measure different fluid levels in tanks.

The 0-100 PSI 0-1 PSI 1/8" Stainless Steel Johnson Pressure Transducer measures pressure from 0 to 100 PSI. It has an NPT 1/8" male thread, 7.3" cable length, fragile glass vessel, and gold plated snap over lens covering.

The Johnson Controls P499RAP-101 is a 5-15 PSI full scale pressure transducer with ½ accuracy that is ideally suited for most applications. It is also ideally suited for flow measurement in most applications either DC or AC signal. Features include 0-100# full scale, ¼" male NPT thread mounting with plastic unions, stainless housing, 3 wire round male connectors, Flanges are not included

The Johnson Control brand is a leader in residential and commercial building efficiency. Their P499RAP-101 pressure transducer can accurately measure from 0-100 pounds per square inch. The 0-100 pounds full scale provides the accuracy required for gauging.

Pressure transducer for Johnson Controls iVent Range Hoods - P499RAP-101

The Johnson Controls PressureTransducer P499RAP-101 range mechanical pressure transducers can be used to measure static pressure or differential pressure. They are designed for maintenance and control applications such as gas and liquid flow, vented loop control, and positive-displacement metering. This product is short-term surge tested to TL6 and long term cycled to TL4 for reliability under changing loads.

The JCI OEM1000 Series manual pressure transducer provides highly accurate pressures needed to control heating, ventilating, air conditioning, and cooling systems. The transducer features a cast-aluminum body with stainless steel temperature sensor horns for corrosion resistance. The screw terminals facilitate installation.

The Johnson Controls pressure transducer is built with high accuracy to provide accurate measurement of pressure where needed. The pressure sensor comes with both aluminum and stainless steel construction, with fast response time to ensure accuracy even in high flow rates. The Johnson Pressure Transducer is ideal for applications such as water-quality monitoring, geothermal applications, wastewater treatment, milk pasteurization, process control, and many more. Built with quality in mind, this pressure transducer will last long and consistently provide accurate measurements over time.

The Johnson Controls Pressure Transducer P499RAP-101 is a direct-reading transducer for converting pressure on a measured media to a proportional pneumatic output signal on a Johnson Controls valve.

The Johnson Controls Pressure Transducer measures both pressure and temperature, ensuring that your HVAC system is operating at peak efficiency. It's easy to install. Two wires connect the sensor to a 24 Volt transformer, which transmits a signal over a 2-wire bus to a compatible control board. Multiple sensors can be linked to the same bus, allowing you to monitor the performance of multiple systems from one control board.

When you need to monitor and control the pressure of a process, Johnson Controls has the solution. The Pressure Transducer accurately measures and communicates information about an environment and how it is changing.