KMC Controls MEP-5061 "24V "24V

"24V

The MEP-5061 "24V is an external drive, PVC water pump. The pump has a 24V, 5W, 1/3 HP universal motor and is a NEMA 11, 50-60Hz, 1 phase rated, Open drip proof enclosure. The brushless pump makes it great for industrial applications that require the pump to run continuously for longer periods due to its power management features.

Our MEP-5061 "24V" 24 VAC air control is an adjustable, general-purpose, single stage, normally closed air control, with a 2 position manual switch.

The MEP-5061 is a 50A hour, "24VAC/DC GMP relay which is supplied with a built-in voltage multiplier providing the accurate switching levels required by programmable controllers, CANopen® devices, or most common electronic circuitry.

The 24V Motor Controller adds an optional 24V DC power supply to the KMC 3.0 or 4.0 PassiveX motion control hardware modules. This allows the system to be used with 24V powered equipment including standard 24V DC servo motors, and 12-24 VDC sensors and power supplies. The controller ships with a 250mA 24VDC regulated power supply. The controller will also work with most common rails, electrolytic or tantalum capacitors from 0.1uf to 1uF at 6VDC or higher voltage up to 5A, 1KOhm resistors for pull-ups

Designed specifically for use with KMC Controls' 24VDC Series. This high-power relay can be used to control simple on/off equipment such as appliances, lighting and fans.

Our "MEP-5061" is a 24VDC, Pulse Width Modulation (PWM) controller. It's designed to work with standard solid state transformers & solenoids.

The MEP-5061 is a 24 volt AC controller voltage interface module. It was designed as a cost effective unit to interface one or two 24 volt coils and accept 0-10V, 4-20ma or 0-20ma control inputs. The module is configured with 24VIN, 24VOUT, the two coil terminals, and the input conditioner terminal.