MERCURY FREE PRESSURETROL, BREAKS O
The Honeywell 2205 is a Mercury-free Pressuretrol SPST 2-15# break on rise manual reset, for use with de-frost cycle applications. Compatible where electronic controls are not required.
The Honeywell 2205 Pressuretrol SPST 2-15# break on rise manual reset features a black steel case, unloader valve, wide range of set points from 1 to 60 psi, and is pneumatic operated. The Pressuretrol controls the water flow from the pump to the sprinklers. The Pressuretrol works by reducing the air pressure behind a piston inlet check valve. When the water pressure goes above a set point, more air is let in by opening an inlet prv allowing more water out. The Pressuretrol will turn off the water supply to the sprinklers if water pressure
The Honeywell 2201, Pressuretrol 5,000 PSI is a break-on-rise 15-psig setting controls. This particular model is an SPST (single pole single throw) 24 VAC/Vdc model with a 2 wire cable and factory installed O-ring. The Pressuretrol Dampers are used to reduce pressure surges in fluid lines that can cause damage to other devices on the line or even result in loss of flow completely. Pressuretrol dampers are also used to maintain a steady flow rate of fluid through a system by reducing system pressure as required. With a wide in
Pressuretrol SPST 2-10 HP with manual reset
Based on a popular design, this Honeywell 2205 Pressuretrol fits the application of a 15# PSI pump for domestic water. Designed for break pressure applications. Please check the manual for more information.
The Pressuretrol is an economical manual reset controller that is suitable for use in residential and light commercial water treatment applications. The Pressuretrol cycle switch automatically turns the pump on and off, allowing the pressure tank to maintain a constant system pressure.
The Honeywell 2205 Pressuretrol is a high quality, stable, fully adjustable and economical pressure switch. It will control most standard solenoid valves and/or electric valves rated up to 15 amps with 5 watts or less for general purpose, fire alarm and many other machine applications. This mini-switch features an SPST ON/OFF manual control lever connected to a SPST START/STOP LIMIT switch which provides reliable and stable switching of load currents in both directions. A non-adjustable give-away opening break sets the limit at 2.0 psig minimum (3.2 kg/cm2