Lennox 10B17 POTENTIAL RELAY POTENTIAL RELAY

POTENTIAL RELAY

The Potential Relay is a solid state replacement for the traditional three-wire electromechanical potential relay. You can change index position and increase the maximum switching capacity to 8A and 12A, which is suitable for electric fan motors. This potential relay features low interference to neighboring circuits and an easy to replace fuse. The solid state design makes this new potential relay superior to traditional relays in performance, safety and reliability.

The Lennox® Potential Relay is a high quality replacement for the most commonly used relay in air conditioning systems. It features self-cleaning brushes to prevent hard and soft build up on the contacts.

When the heating equipment requires a potential relay but will not allow for cabling to the control board, a Lennox Potential Relay can be utilized for transferring the signal from the panel to the high voltage connectors. This relay is rated at 24 amps and up to 600 volts AC.

The Lennox 10B17 Potential Relay is a replacement relay for the XC10B10007 High Efficiency Furnace. This replacement relay is not for stand alone use and will require referencing your original wiring to install.

With a range of split-phase and 5-wire potential relays, Lennox has a relay for all of your HVAC controls needs. With solid-state construction, these relays are built to last.

The 10B17 Potential relay from the Lennox® air conditioning product line is a single pole, snap action potential relay system in a miniature potted case. The 10B19 is a single pole, snap action potential relay system in a miniature potted case.

A Potential Relaying Module (PRM) is a type of device that may be installed into a Lennox® heating and/or cooling system to reduce the potential for nuisance malfunctions caused by field failure of individual components in that system. The PRM is connected in parallel with the HVAC system's outdoor compressor motor.